Quick Start Manual

Table Of Contents

www.mythinkcar.com

THINKSCAN Plus

This function can initialize the adaptive headlight system. This system can decide whether

to automatically turn on the headlights based on the ambient light intensity, monitor the

vehicle’s driving speed, body posture, etc., and adjust the headlight lighting angle timely.

2.2.13 Gearbox matching

This function can complete the self-learning of the gearbox and improve the shift quality.

When the gearbox is disassembled or repaired (after some batteries are powered oﬀ ), it

will cause shifting delay or car impact. At this time, this function is to make the gearbox

automatically compensate according to driving conditions, thus achieve more comfortable,

more ideal shift quality.

2.2.14 Sunroof initialization

This function can set the sunroof lock oﬀ , close in rain, memory function of sliding / tilting

sunroof, outside temperature threshold, etc.

2.2.15 EGR Adaption

This function is used to learn the EGR (Exhaust Gas Recirculation) valve after it is cleaned

or replaced.

2.2.16 Gear Learning

The crankshaft position sensor learns crankshaft tooth machining tolerance and saves

to the computer to more accurately diagnose engine misfires. If tooth learning is not

performed for a car equipped with Delphi engine, the MIL turns on after the engine is

started. The diagnostic device detects the DTC P1336 'tooth not learned'. In this case, you

must use the diagnostic device to perform tooth learning for the car. After tooth learning is

successful, the MIL turns oﬀ .

After the engine ECU, crankshaft position sensor, or crankshaft ﬂ ywheel is replaced, or the

DTC 'tooth not learned' is present, tooth learning must be performed.

2.2.17 ODO Reset

a) ODO reset is to copy, write, or rewrite the value of kilometers in the chip of odometer

by using a car diagnostic computer and data cable, so that the odometer shows the actual

mileage.

b) Usually when the mileage is not correct due to the damaged vehicle speed sensor or

odometer failure, it is necessary to do ODO reset after maintenance.

2.2.18 Airbag Reset

This function resets the airbag data to clear the airbag collision fault indicator. When the

vehicle collides and the airbag deploys, the corresponding fault code of the collision data