Quick Start Manual

Table Of Contents

www.mythinkcar.com

THINKSCAN Plus

appears, the airbag indicator lights up, and the fault code cannot be cleared. Since the

data inside the airbag computer is disposable, it is required that all new accessories must

be replaced, but after performing this function, the data of the airbag computer can be

recovered and the fault code can be cleared, the airbag light will go out, and the airbag

computer can continue to use.

2.2.19 Transport Mode

In order to reduce power consumption, the following functions may be disabled, including

limiting the vehicle speed, not waking up the door opening network, and disabling the

remote control key, etc. At this time, the transport mode needs to be deactivated to restore

the vehicle to normal.

2.2.20 A/F Reset

This function is applied to set or learn Air/Fuel ratio parameters.

2.2.21 Stop/Start Reset

This function is used to open or close the automatic start-stop function via setting the

hidden function in ECU (provided that the vehicle has a hidden function and supported by

hardware).

2.2.22 NOx Sensor Reset

NOx sensor is a sensor used to detect the content of nitrogen oxides (NOx) in engine

exhaust. If the NOx fault is re-initialized and the NOx catalytic converter is replaced, it is

necessary to reset the catalytic converter learned value stored in the engine ECU.

2.2.23 AdBlue Reset (Diesel Engine Exhaust Gas Filter)

After the diesel exhaust treatment fluid (car urea) is replaced or filled up, urea reset

operation is required.

2.5.24 Seat Calibration

This function is applied to match the seats with memory function that are replaced and

repaired.

2.2.25 Coolant Bleeding

Use this function to activate the electronic water pump before venting the cooling system.

2.2.26 Tyre Reset

This function is used to set the size parameters of the modiﬁ ed or replaced tire.