User Manual

www.mythinkcar.com

THINKTOOL Pros

3.5.14 A/T Learning

This function can complete the gearbox self-learning to improve gear shifting quality. When the gearbox is

disassembled or repaired (after some of the car battery is powered oﬀ ), it will lead to shift delay or impact

problem. In this case, this function needs to be done so that the gearbox can automatically compensate

according to the driving conditions so as to achieve more comfortable and better shift quality.

3.5.15 Sunroof Initialization

This function can set the sunroof lock oﬀ , closed when it rains, sliding / tilting sunroof memory function,

temperature threshold outside the car etc.

3.5.16 EGR Adaption

This function is used to learn the EGR (Exhaust Gas Recirculation) valve after it is cleaned or replaced.

3.5.17 ODO Reset

a) ODO reset is to copy, write, or rewrite the value of kilometers in the chip of odometer by using a car

diagnostic computer and data cable, so that the odometer shows the actual mileage.

b) Usually when the mileage is not correct due to the damaged vehicle speed sensor or odometer failure, it

is necessary to do ODO reset after maintenance.

3.5.18 Airbag Reset

This function resets the airbag data to clear the airbag collision fault indicator. When the vehicle collides

and the airbag deploys, the corresponding fault code of the collision data appears, the airbag indicator

lights up, and the fault code cannot be cleared. Since the data inside the airbag computer is disposable,

it is required that all new accessories must be replaced, but after performing this function, the data of the

airbag computer can be recovered and the fault code can be cleared, the airbag light will go out, and the

airbag computer can continue to use.

3.5.19 Transport Mode

In order to reduce power consumption, the following functions may be disabled, including limiting the

vehicle speed, not waking up the door opening network, and disabling the remote control key, etc. At this

time, the transport mode needs to be deactivated to restore the vehicle to normal.

3.5.20 A/F Reset

This function is applied to set or learn Air/Fuel ratio parameters.

3.5.21 Stop/Start Reset

This function is used to open or close the automatic start-stop function via setting the hidden function in

ECU (provided that the vehicle has a hidden function and supported by hardware).