User Manual

www.mythinkcar.com
THINKTOOL Pros
II
The device is a sealed device with no user-serviceable parts inside. All internal repairs must be performed
by an authorized maintenance organization or qualifi ed technician. Attempts to disassemble or modify the
device will void the warranty.
Do not try to replace the internal battery
The internal rechargeable lithium battery must be replaced by an authorized maintenance organization or
qualifi ed technician. Contact the dealer for factory replacement.
Adapter information
Avoid immersing the device in water or placing it in a location where it may absorb moisture or other liquids.
During normal use, the charging device may become hot. Please ensure that there is good ventilation
while charging device.
If any of the following situation occurs, please unplug the charging device:
The charging device is exposed to rain, liquid or in an environment with excessive overlap.
The charging device showed physical damage.
Cleaning the charging device.
Data and Software Protection
Do not delete unknown fi les or change the names of fi les or directories created by others, otherwise the
device software may not run.
Note: Access to network resources makes the device vulnerable to computer viruses, hackers, spyware, and
other malicious behaviors, and may damage the device, software, or data. To make ensure that you are using
fi rewalls, anti-virus software and anti-spyware software to provide adequate protection for your computer and
keep these software up to date.
Precautions on Using this tool
To make sure the ignition switch should be in the OFF position when plugging and unplugging the
diagnostic connector.
Keep the connector in the storage box on the back of the main unit, when the vehicle diagnosis is fi nished.
Gently press the diagnostic connector to pop up the diagnostic connector. Do not pull or use sharp
objects to pry the diagnostic connector.
Precautions on Operating Vehicle’s ECU
Do not disconnect battery or any wiring cables in the vehicle when the ignition switch is on, as this could
avoid damage to the sensors or the ECU.
Do not place any magnetic objects near the ECU. Disconnect the power supply to the ECU before
performing any welding operations on the vehicle.
Use extreme caution when performing any operations near the ECU or sensors. Ground yourself when
you disassemble PROM, otherwise ECU and sensors can be damaged by static electricity.
When reconnecting the ECU harness connector, be sure it is attached firmly, otherwise electronic
elements, such as ICs inside the ECU, can be damaged.
！