Product Info

www.thinkcar.com

THINKTOOL X10

2.5 Battery use

• If the battery has not been used for a long time or the battery is exhausted, it may not be able to start

up the machine properly when charging. This is normal. Please charge the battery for a period of time

before starting the machine.

• Please use the attached charger for charging. The Company will not be responsible for any damage

or loss caused by using other chargers other than those speciﬁ ed by the Company.

• The battery can be recharged. But since the battery is a consumable, after a long time of use, the

standby time of the equipment will be shortened. To extend the service life of the battery, avoid

frequent recharging.

• The battery charging time varies with temperature conditions and battery usage.

• When the battery of the equipment is low, the system will pop up the prompt of connecting the

charger. When the battery is too low, the equipment may be automatically shut down.

2.6 Diagnosis equipment connection

The connection steps are as follows:

1. Find the diagnosis seat on the vehicle. Most of the diagnosis seats are standard OBDII diagnosis

seats (non-standard OBDII vehicle diagnosis seats require corresponding adapters) and are generally

mounted on the driver's side, 12 inches from the center of the instrument panel. If you cannot ﬁ nd the

location of the vehicle diagnosis seat, please consult the vehicle maintenance manual.

A Opel, Volkswagen, Audi

B Honda

C Volkswagen

D Opel, Volkswagen, Citroen

E Changan

Hyundai, Daewoo, Kia, Honda, Toyota, Nissan,Mitsubishi,

Renault, Opel, BMW, Mercedes-Benz, Mazda, Volkswagen,

Audi, GM, Chrysler,Peugeot, Regal, Beijing Jeep, Citroen and

most prevailing models

2. Connect the diagnosis equipment with the diagnosis seat on the vehicle.

Note: for the non-standard OBDII diagnosis seat, if the diagnostic block is insuﬃ cient in power, power supply can

be obtained in a battery double-embedded wire mode.