Product Info

www.thinkcar.com
THINKTOOL X10
20
5.7 DPF Reg.
The DPF regeneration function is mainly to regularly remove particles in the trap by using a combustion
oxidation method (e.g. high temperature heating combustion, and combustion with fuel additives or
catalysts to reduce the ignition point of particles), so that the trap performance is always kept at the best
stability.
Situations where DPF regeneration matching is required:
a) The exhaust back pressure sensor is replaced.
b) The particle trap is dismounted or replaced.
c) Fuel additive injector is dismounted or replaced.
d) The catalytic oxidizer machine is dismounted or replaced.
e) The DPF regeneration fault indicator lights on, and matching is needed after repairing.
f) The DPF regeneration control module is repaired or replaced.
5.8 Gear Learn
It means self-adaptive learning of crankshaft position sensor. The crankshaft position sensor can learn
the machining error of crankshaft gear and store it in the computer, so as to diagnose engine misfi re
more accurately. If a vehicle installed with Delphi engine has not undergone gear signal learning, the
fault indicator will light up after starting the engine. When detecting with diagnosis equipment, there will
be a fault code that P1336 gear signal has not been learned. At the moment, the diagnosis equipment
must be used to perform the special function of gear signal learning on the vehicle. The fault indicator is
off after this function is successfully completed. Gear signal learning is required in case of replacement
of engine ECU, crankshaft position sensor, crankshaft flywheel, and fault code with unlearned gear
signal.
5.9 Immo
In order to prevent the vehicle from being used by illegal keys, the anti-theft key matching function
enables the anti-theft control system on the vehicle to identify and authorize the remote key before
vehicle car can be started and used normally. In addition, when replacing the ignition key, ignition switch,
combined instrument panel, engine control unit (ECU), body control module (BCM), and remote control
battery, immobilizer matching is required.
5.10 Injector
Write the actual injector code or rewrite the code stored in the ECU into the code corresponding to the
injector of each cylinder, so as to control or correct the amount of fuel injection of each cylinder more
accurately. Generally after the ECU and injector are replaced, it is necessary to confi rm or recode the
injector code of each cylinder, so that the cylinder can better identify each injector and accurately
control fuel injection.
5.11 TPMS Reset
When the tire pressure failure indicator lights on, after repairing, it is necessary to reset the tire pressure
through the tire pressure reset function and put out the tire pressure failure indicator. When maintenance
that the tire pressure is too low or leakage happens, tire pressure monitoring equipment is replaced or
installed, tires are replaced, the tire pressure sensor is damaged, tire transposing of vehicle with tire
pressure monitoring function is carried out, et., is completed, the tire pressure of the vehicle should be
reset.
5.12 Sus Reset
The height of the vehicle body can be adjusted with this function. When the body height sensor and