Product Info

www.thinkcar.com

THINKTOOL X10

control module in the air suspension system are replaced or the levelness of the vehicle is incorrect, it is

necessary to perform this function to adjust the body height sensor for level calibration.

5.13 AFS Reset

The self-adaptive headlight system can be initialized with this function. The self adaptive headlight

system can decide whether to automatically turn on the headlights according to the intensity of the

ambient light, and monitor the driving speed of the vehicle, the posture of the body, and adjust the

lighting angle of the headlights in time.

5.14 GearBox Learn

This function can complete self-learning of the gearbox and improve the shift quality. When the gearbox

is dismounted or repaired (after the power failure of accumulators in some vehicles), shift delay or

impact problem can be caused. At this time, it is necessary to perform this function, so that the gearbox

can automatically compensate according to the driving conditions, so as to achieve more comfortable

and ideal shift quality.

5.15 Sun Roof

With this function, skylight locking and closing, memory function of closing, sliding/tilting of the skylight

when it rains, outside temperature threshold, etc. can be set up.

5.16 EGR Adaption

With this function, parameters can be adjusted to activate the exhaust gas retreatment system.

5.17 ODO Meter

a) Meter calibration is copy, writing or rewriting of the mileages, that is, to copy, write or rewrite the data

from the chip in the meter by using the vehicle diagnosis computer and the data line, so that the

meter shows the actual mileage.

b) Usually, when the speed sensor is damaged and the mileage is not accurate due to meter fault,

mileage calibration is needed after repairing.

5.18 Airbag Reset

With the function, airbag data can be reset, and airbag collision fault indicator can be terminated. When

the vehicle has a collision and the airbag is opened, the fault code corresponding to the collision data will

appear. The airbag indicator lights on, and the fault code cannot be cleared. Since the data in the airbag

computer is one-time, it is necessary to replace all new accessories according to the requirements.

However, after performing this function, the data of the airbag computer can be restored, and the fault

code can be cleared. The airbag indicator will light oﬀ , and the airbag computer can continue to use.

5.19 Transport Mode

In order to reduce the power consumption of the vehicle, protection such as vehicle speed limit, no door

open network awakening, and disabled remote control key can be enabled, then the transport mode

needs to be released to restore the vehicle to normal.

5.20 A/F Reset

It aims to set or learn air/fuel ratio parameters.