Setup Guide
Table Of Contents
- Notices
- About Thinkify, LLC
- A Quick RFID Introduction
- Thinkify Reader Protocol Overview
- Command Reference
- Summary
- "A" – RX Amplifier Control
- "BOOTLOADER" – Enter Bootloader
- "C" – Low-Level Chip Control Registers
- "F" – RX Filter Control
- "G" – GPIO Settings
- “I” – Inventory Control
- "K" – Kill, Lock, Access Descriptors
- “M" – MASK / SELECT control
- “NM" – Macro Control
- "P" – PROTOCOL control (Gen2 Air protocol)
- "R" – RF Control
- "RP" and "RM" – Multiplexing (Antenna Control)
- "T" – Initiate INVENTORY
- "X" – eXtra Data Read and Write Descriptor Control
About Thinkify, LLC
“NM" – Macro Control ......................................................................................................................................... 37
"P" – PROTOCOL control (Gen2 Air protocol).................................................................................................38
"R" – RF Control...................................................................................................................................................... 40
"RP" and "RM" – Multiplexing (Antenna Control)............................................................................................42
"T" – Initiate INVENTORY...................................................................................................................................... 44
"X" – eXtra Data Read and Write Descriptor Control....................................................................................49
10