Setup Guide
Table Of Contents
- Notices
- About Thinkify, LLC
- A Quick RFID Introduction
- Thinkify Reader Protocol Overview
- Command Reference
- Summary
- "A" – RX Amplifier Control
- "BOOTLOADER" – Enter Bootloader
- "C" – Low-Level Chip Control Registers
- "F" – RX Filter Control
- "G" – GPIO Settings
- “I” – Inventory Control
- "K" – Kill, Lock, Access Descriptors
- “M" – MASK / SELECT control
- “NM" – Macro Control
- "P" – PROTOCOL control (Gen2 Air protocol)
- "R" – RF Control
- "RP" and "RM" – Multiplexing (Antenna Control)
- "T" – Initiate INVENTORY
- "X" – eXtra Data Read and Write Descriptor Control
Notices
Notices
Copyright ©2020 Thinkify, LLC. All rights reserved.
Thinkify, LLC has intellectual property rights relating to technology embodied in the products
described in this document, including without limitation certain patents or patent pending
applications in the U.S. or other countries.
This document and the products to which it pertains are distributed under licenses restricting
their use, copying, distribution and decompilation. No part of this product documentation may
be reproduced in any form or by any means without the prior written consent of Thinkify, LLC
and its licensors, if any. Third party software is copyrighted and licensed from Licensors.
Thinkify, the Thinkify logo, Insight and other graphics, logos, and service names used in this
document are trademarks of Thinkify, LLC in the U.S. and other countries. All other trademarks
are the property of their respective owners. U.S. Government approval required when
exporting the product described in this documentation.
Federal Acquisitions: Commercial Software -- Government Users Subject to Standard License
Terms and Conditions. U.S. Government: If this Software is being acquired by or on behalf of
the U.S. Government or by a U.S. Government prime contractor or subcontractor (at any tier),
then the Government's rights in the Software and accompanying documentation shall be only
as set forth in this license; this is in accordance with 48 C.F.R. 227.7201 through 227.7202-4 (for
Department of Defense (DoD) acquisitions) and with 48 C.F.R. 2.101 and 12.212 (for non-DoD
acquisitions).
DOCUMENTATION IS PROVIDED “AS IS” AND ALL EXPRESS OR IMPLIED CONDITIONS,
REPRESENTATIONS AND WARANTEES, INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY, FITNESS FOR APARTICULAR PURPOSE OR NON-INFRINGMENT ARE
HEREBY DISCLAIMED, EXCEPT TO THE EXTENT THATSUCH DISCLAIMERS ARE HELD TO BE
LEGALLY INVALID.
Note Regarding RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of 20
cm in the US or 33cm, (Canada), between the radiator (antenna) and your body. This
transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
2