Setup Guide
Table Of Contents
- Notices
- About Thinkify, LLC
- A Quick RFID Introduction
- Thinkify Reader Protocol Overview
- Command Reference
- Summary
- "A" – RX Amplifier Control
- "BOOTLOADER" – Enter Bootloader
- "C" – Low-Level Chip Control Registers
- "F" – RX Filter Control
- "G" – GPIO Settings
- “I” – Inventory Control
- "K" – Kill, Lock, Access Descriptors
- “M" – MASK / SELECT control
- “NM" – Macro Control
- "P" – PROTOCOL control (Gen2 Air protocol)
- "R" – RF Control
- "RP" and "RM" – Multiplexing (Antenna Control)
- "T" – Initiate INVENTORY
- "X" – eXtra Data Read and Write Descriptor Control
"K" – Kill, Lock, Access Descriptors
kl0
ACTIVE=0
LOCKBITS=A0280
Try to read without access:
t6
STARTINVENTORY
TAG=3000E2001AC1909F6580000EED95 902250 02 0 E Q 4A35
XRD0=TAG ERRORCODE 04
XRD1=5F7D3000E2001AC1909F6580000EED95
XRD2=E2003414011F0100
XRD3=00000000
STOPINVENTORY 0x004A EPCCOUNT=1
You can't see the access password or kill password!
Use the right access password and go into secure state:
ka22222222
ACCESSPASSWORD=22222222
t61
STARTINVENTORY
TAG=3000E2001AC1909F6580000EED95 902250 03 0 E Q 6812
ACCESS=SUCCESS
XRD0=1111111122222222
XRD1=5F7D3000E2001AC1909F6580000EED95
XRD2=E2003414011F0100
XRD3=00000000
STOPINVENTORY 0x0060 EPCCOUNT=1
With the right access password, we can now read the Locked Reserved memory.
32