User Guide
Table Of Contents
- Note Regarding RF Exposure.
- FCC Notice and Cautions
- Compliance FCC Part 90
- Acceptable Frequencies
- Migrating from Thinkify HSP2_0 to HSP3_0 firmware
- Ethernet Communication between HOST and THINKIFY HSP3.0
- Output and Status Messaging in the Thinkify HSP3.0 system
- IO and Timing control in the Thinkify HSP3.0 System
- System Type Functions and control in the Thinkify HSP3.0 system
- Using the LOCK function in Thinkify HSP3.0
- Controlling the programming list database in the Thinkify HSP 3.0 system
As the data entry commands are executed they will be written to the database in
ascending order in a circular addressing fashion from 0x0000 to 0xFFFF, and conversely
when triggers occur entries will retrieved in a FIFO manner - the oldest unused database
entry will be used first.
Four other commands will affect the database.
RESETBUFFER is somewhat self explanatory - all entries in the database will be reset
to NULL length and the available buffer entry count will be set to zero.
READBUFFER - All data in database will be reported - user should be aware this could
result in a very long communication stream if the generate command has been used to fill
a large number of database structures
GETBUFFERCOUNT will return the number of currently filled but unused database
structure entries
AUTOCLEAR=<ON or OFF> controls the behavior of the buffer when the system
triggering is enabled/disabled through a ENGAGE or DISENGAGE. If it is ON any
transition from ENGAGE to DISENAGE or vice versa will result in a RESETBUFFER
being executed.
Copyright 2014 Thinkify LLC. All Rights Reserved.
Thinkify, LLC, 18450 Technology Drive, Suite E1, Morgan Hill, Ca. 95037, www.thinkifyit.com 408-782-7111