Full Product Manual
Connecting External GPS Receiver
-External GPS Receiver enables dash cam to record vehicle
location information embedded in the video les. This infor-
mation can be viewed using THINKWARE Dash Cam Viewer
on PC to track the driving route including location and speed
that are displayedon Google map within the PC viewer.
Connect the external GPS receiver to the GPS port of the dash
cam.
During installation, place the GPS receiver away from the dash cam
main unit to reduce noise interference.
THINKWARE shall NOT be responsible for any problems and/or
damages that may occur from not using genuine or authorized parts
and accessories. It is strongly recommended that only the THINKWARE
external GPS receiver is used on the dash cam.
Turn the device off completely before connecting the external GPS
receiver to avoid damages.
Cautions
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
FCC Compliance Statement
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications,
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution : Any changes or modications to the equipment not expressly
approved by the party responsible for compliance could void your
authority to operate the equipment.
Note : This unit was tested with shielded cables on the peripheral devices.
Shielded cables must be used with the unit to insure compliance.
This Class A digital apparatus complies with Canadian ICES-003