Owner's Manual
Table Of Contents
- User Guide
- Safety information
- 1. Product overview
- 2. Installing the product
- 3. Using recording features
- 4. Using the mobile viewer
- 5. Using the PC viewer
- 6. Settings
- 6.1 Managing the memory card
- 6.2 Setting the camera
- 6.3 Setting recording features
- 6.3.1 Setting the continuous impact detection sensitivity
- 6.3.2 Setting parking mode
- 6.3.3 Setting the impact sensitivity in parking mode
- 6.3.4 Setting the motion detection sensitivity
- 6.3.5 Setting the record timer feature
- 6.3.6 Setting the battery protection feature
- 6.3.7 Setting the battery cutoff voltage feature
- 6.3.8 Setting the battery protection feature for wintertime
- 6.4 Setting road safety features
- 6.5 Configuring the system settings
- 7. Accessing the product information
- 8. Upgrading the firmware
- 9. Troubleshooting
- 10. Specifications
- Quick Start Guide
- Warranty
Installing
the
product
Select
an
installation
location
that
can
record
the
entire
view
in
front of
the
vehicle
without
obstructive
the
driver's
vision
.
Ensure
that
the
front
camera
lens
is
located
in
the
center
of
the
windshield
.
1.
Refer
to
the
figures
below
to
install
the
camera
to
the
windshield.
2.
Remove
the
product from
the
mount,
and
then
push
the
mount
against
the
windshield
to
fix
it
firmly.
3.
Reattach
the
product
to
the
mount,
and
then
adjust
the
camera
angle.
•
To
confirm
the
camera
angle,
record
a
video
after
installation
and
check
the
video
using
the
mobile
viewer
or
the
PC
viewer.
If
necessary,
adjust
the
camera
angle
again.
•
The
product
may
fall
and
be
damaged
during
vehicle
operation
if it
is
not
firmly
f1Xed
to
the
mount
•
If
you
need
to
remove
the
mount
from
the
windshield
to
alter
the
installation
location,
be
careful
not
to
damage
the
windshield's
film
coat.
7