User's Manual

3millID 9249 S. Broadway Building #200 Suite 826 Highlands Ranch CO 80129
[phone]
[e-mail]
© 3millID
100-02640-A
www.3millid.com
MANUAL
3M
S-Gang
Keypad
4. END of keypad programming guide
12
set PIN
PIN CODES
*98
set engineer’s PIN code
LOG OFF
PIN CODES
*99
EXIT CONFIGURATION MODE
example
*98oooonnnn#
oooo
nnnn
.....
.....
example
*99#
The following instructions give a step-by-step procedure for accessing the many features
supported by this reader.
4. keypad programming guide
Use this code to change the factory default PIN to your own
4 digit engineer’s PIN setting.
The factory default PIN = 1234
To set your new PIN to 6789 enter: *9812346789# once
the reader has been placed into programming mode.
After entering programming mode, the reader will time out
after approximately 30 seconds if no keys are pressed for
that duration. Any changes you may have made to values or
settings will be lost.
Remember to keep a record of your new PIN.
NOTE:
If you forget your PIN setting, you will need to contact your
INSTALLER or SUPPLIER to obtain a RESET code.
WARNING:
6
8
0
9
#
4
7
*
5
1 2 3
current PIN (4 digits) (factory default = 1234)
engineer’s PIN setting (4 digits)
Use this code to EXIT the CONFIGURATION MODE of the
reader.
Enter: *99# to exit CONFIGURATION MODE (and save any
settings made).
After entering programming mode, the reader will time out
after approximately 30 seconds if no keys are pressed for
that duration. Any changes you may have made to values or
settings will be lost.
You MUST use this code to ensure any changes to values
or settings you may have made, are safely SAVED to the
reader.
NOTE:
6
8
0
9
#
4
7
*
5
1 2 3