Installation Instructions

These RFID proximity readers comply with the essential requirements and relevant provisions
of:
EU Directive 2014/53/EC
This symbol on the product or on its packaging indicates that the product must not be
disposed of with normal household waste. Instead, it is your responsibility to dispose of your
waste equipment by arranging to return it to a designated collection point for the recycling of
waste electrical and electronic equipment. By separating and recycling your waste equipment
at the time of disposal you will help to conserve natural resources and ensure that the
equipment is recycled in a manner that protects human health and the environment.
EU Directive 2012/19/EU
UTJ-PRX60BLE
c o m p l i a n t
R o H S
Together with information provided by suppliers and subcontractors, these devices comply with
the requirements and relevant provisions of:
EU Directive 2011/65/EC.
This Installation Guide is available
as a download -
please scan the QR code.
C US
TYPE S
BP20790
IC: 21820-PRX60BLE
These devices comply with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.
Changes or modifications not expressly approved by the party responsible for
compliance would void the user’s authority to operate the equipment.
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference; and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
OUT-OF-THE-BOX … pull bottom
edge of reader module away from
the backplate, and lift up.
Mount the reader backplate to
a flat surface using suitable
hardware having a diameter no
greater than 4mm (0.15inch).
Position the reader module, ensuring
the top-edge fixing lugs engage
correctly with the recesses located at
the top of the backplate.
Swing the bottom edge of the
module down and forward until
you feel the unit click shut.
Secure the reader module to
the backplate using the
M3x10mm screw supplied.
1
2
3
4
5
6
7
8
9
10
• 0V Supply voltage ground
• +Vdc Supply voltage (+5Vdc to +16Vdc)
• DATA1/CLK Wiegand or Clock & Data output
• DATA0/DAT Wiegand or Clock & Data output
• GREEN Green LED control input
• RED Red LED control input
• BUZZER Buzzer control input
• TMPR/CP Tamper or Card Present output
• RS485 - RS485 Bus
• RS485 + RS485 Bus
Make terminal block connections in accordance with the pin-out
wiring diagram shown below.
To avoid damaging the screw heads, use a 2.5mm flat head
screwdriver only.
6
5
4
32
1
The illustrations and notes below are provided as a general guidance for mounting, fixing and connecting the RX series of RFID readers.
Always consult your installer and the manufacturer‘s details of your door controller when configuring your access security system.
NOTE:
Ensure you orientate the
backplate correctly.
If required, you may use an
M3x10mm security screw
(not supplied).