Daim Ntawv Qhia Tus Neeg Siv

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 234704_20.04.2021
Quick Start Guide
This quick start guide contains important information on the safe operation of the
product. Read and follow the safety advice and instructions given. Retain the quick
start guide for future reference. If you pass the product on to others please include
this quick start guide.
EN
Safety instructions
Intended use
This device is intended to be used for the wireless reception of audio signals in the
wireless tour guide system TG 16. Any other use or use under other operating con-
ditions is considered to be improper and may result in personal injury or property
damage. No liability will be assumed for damages resulting from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are
not within reach of babies and young children. Choking hazard! Ensure
that children do not detach any small parts from the product. They could
swallow the pieces and choke! Never let children unattended use electri-
cal devices.
Where to use the product
Never use the product
• in conditions of extreme temperature or humidity
• in extremely dusty or dirty areas
• at locations where the unit can become wet
General handling
• To prevent damage, never use force when handling the product.
• Never immerse the product in water. Just wipe it with a clean dry cloth. Do not
use liquid cleaners such as benzene, thinners or ammable cleaning agents.
Notes on wireless transmission
This device utilizes frequencies that are not harmonized within the European Union
(EU) and therefore may only be used in certain EU member states. In all European
countries, the frequencies used for the transmission of audio signals are strictly regu-
lated. Before you start, make sure the frequencies are allowed in the respective coun-
try and check whether the operation must be reported to the appropriate authority.
For more information, please visit: http://www.thomann.de.
• Make sure that transmitter and receiver are both tuned to the same channel.
• Never set multiple transmitters to the same channel.
• Make sure that there are no metal objects between the transmitter and receiver.
• Avoid interference from other radio or in-ear systems.
Electromagnetic compatibility with other electrical equipment
Using the device near radios or TV sets may cause interference. Then increase the dis-
tance between the devices.
Incorrect handling of lithium batteries can result in injury
• In the event of a short circuit, overheating or mechanical damage, lithium batteries
can cause severe injuries.
• When handled correctly and appropriately lithium batteries pose no risk.
• Store lithium batteries in a cool, dry place, ideally in the original packaging.
• Store lithium batteries away from heat sources (e.g. radiators or sunlight). Lithium
batteries are hermetically sealed. Never attempt to open a lithium battery.
• If the battery housing is damaged small amounts of the electrolyte may leak out. If
this should happen, seal the lithium battery in airtight packaging and wipe up the
traces of electrolyte using absorbent paper towels. You must wear protective rub-
ber gloves when doing so. Clean your hands and the aected surface thoroughly
with cold water.
• Never attempt to recharge non-rechargeable lithium batteries. When charging
lithium batteries you must use a suitable charging device intended for the purpose.
• Before disposing of the device remove the lithium batteries. Protect used lithium
batteries against potential short circuits, e.g. by covering the poles with adhesive
tape.
• Only use powder extinguishers or other suitable extinguishing agents to extinguish
a burning lithium battery.
Controls and connections
863~865MHz
863~865MHz
ö * +-#$
&
%
'
(
,
)
ö [POWER] Main switch. Turns the device on and o.
To turn the device on, press the button until the control LED lights
up green. To turn the device o, press the button until the control
LED turns o.
# [RESET] Reset button for resetting the device to factory defaults
$ [MIC INPUT] 3.5 mm mini phone socket (mono) to connect the supplied earset
microphone or another microphone
% Notches for threading the band
& Belt clip
' Display
( [CHANNEL] Channel selection button
) Indicating the frequency range in which the device operates. The indication here
must match the information on the receiver.
* Charging contacts
+ [MIC] Built-in microphone
, [VOL] Volume control
- LED to indicate the operating status.
The LED lights up green when the device is turned on.
The LED lights up red when the charge of the built-in battery is too low.
Transmitter 16 T for Tour Guide
Features
• Displays for set channel and operating status
• Integrated chargeable lithium battery
• Charging contacts for charger system TG C2 (item no. 234706) and TG C18
(item no. 235603)
• Built-in microphone
• Housing colour: Black
• 3.5 mm output for separate microphone
• Suitable earset microphone, cloth pouch for storage, band and belt clip
included.