Installation Manual

ManualsBrandsThomas & Betts ManualsFittingsLiquidtight Connector, 45°, 3/8", Insulated, Malleable Iron

Trade

size of

fitting

(in.)

Tightening

torque

(lb.-in.)

 

½" 

¾" 

 

 

 

 

 

 

 

 

Gland nut

Liquidtight

flexible metal

conduit

Nylon sealing ring

Safe Edge™ cone

Box wall

Locknut

Lock to body

(See torque table below)

Body

See step 5

Knockout box

Body

Only Chase

Nipple

goes inside of

knockout

Blue

insulator

throat

Captive “O” ring

5371

series

Read “Box side”

for correct

position on

outside of box

“O” ring

5365 to 5370

Body

1 Piece sealing ring

5361 to 5364

have captive

“O” ring

Wear hand protection.

Wear eye protection.





Installation instructions

1. Cut the flexible conduit with a clean square end cut. (Figure 1)

• Use metal jig (available from conduit manufacturers).

• Use 32 Tooth/ln. no. set, sharp hacksaw.

• For high production use 24-32 Tooth/ln. wavy set, power band

saw, not more than 400’/minute.

• Do not use an abrasive wheel.

2. Assembly

• For 5000, 7000, and 9000 series & PVC coated 3300 series.

(Figure 2)

a. Slide on gland nut.

b. Slide on nylon sealing ring.

c. Thread in Safe Edge™ Cone.

• For PVC coated connector, use the same assembly method,

except tighten with smooth jaw wrench. If gouging occurs

exposing metal, PVC cement is recommended.

• For knockout applications, use T&B® 140 series locknuts and

5260 series sealing gaskets. (Purchase separately)

• For 7000 and 9000 series , order locknut separately.

“Space Saver” Chase® connector assemblies





• Lock-up can be made by tightening Chase® Nipple to body

or by turning body onto Chase® Nipple.



Liquidtight connectors | Installation guide | TA00210 F

—

tnb.abb.com

tnb.ca.abb.com

abb.com

Warranty: tnb.abb.com/ecpwarranty

—

We reserve the right to make technical

changes or modify the contents of this

document without prior notice. With

regard to purchase orders, the agreed

particulars shall prevail. ABB does not

accept any responsibility whatsoever for

potential errors or possible lack of

information in this document.

We reserve all rights in this document and

in the subject matter and illustrations

contained therein. Any reproduction

– in whole or in part – is forbidden without

prior written consent of ABB.

