Cut Sheet

Terminal Products and Tools
Application Tools
Air-Operated Bench-Mounted Tool
CAT. NO. DESCRIPTION PKG. QTY.
25000 This compact heavy-duty air tool installs nylon 1
insulated Sta-Kon
®
terminals on wire sizes from
8 AWG to 250 mcm; non-insulated styles are also
installed just as quickly and dependably; Heavy-duty
air tool installs non-insulated and insulated Sta-Kon
®
terminals from 8 AWG to 250 mcm
NOTE: This tool uses the same dies as the TBM6 and TBM6S hand tools on page F-35.
• Convenience and Economy
The tool accepts a full range of interchangeable dies, the same as used
in the TBM6 or TBM6S tools. To install the dies, simply pull the spring-
loaded pin and remove the indentor die. Then, flex the retaining spring
and remove the die nest.
• Shure-Stake
®
Mechanism Means Quality Connections
The Shure-Stake
®
mechanism senses inlet air pressure, and
if insufficient, is designed to prevent the tool from cycling.
Thus you avoid “undercrimping.” An 85–90 psi air pressure
source is required.
• Safety Features Increase Productivity,
Reduce Downtime
Safety features include a guard over the die area, an
air shutdown switch activated by a slight push with the
finger, and an enclosed foot pedal designed to prevent
unwanted tool operation. In addition, the tool may
be bench-mounted for stability and control. For
convenience when crimping large size terminals
on heavy wire, the head assembly may overhang
the workbench.
Crimps 8 AWG–250 mcm!
F-41
United States
Tel: [phone]
800.816.7809
Fax: [phone]
Technical Services
Tel: [phone]
www.tnb.com