Data Sheet

MKP336 2 X2
www.vishay.com
Vishay BCcomponents
Not for New Designs - Alternative Device: MKP339 X2
Revision: 25-Jul-2019
12
Document Number: 28120
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
SUB-GROUP C1B PART OF
SAMPLE OF SUB-GROUP C1
4.9.2 Final measurements Visual examination No visible damage
Capacitance |C/C|  5 % of the value measured initially
Tangent of loss angle Increase of tan :
 0.008 for: C  1 µF or
 0.005 for: C > 1 µF
Compared to values measured initially
Insulation resistance As specified in section “Insulation resistance”
of this specification
SUB-GROUP C1 
COMBINED SAMPLE OF
SPECIMENS OF SUB-GROUPS
C1A AND C1B
4.11 Climatic sequence
4.11.1 Initial measurements Capacitance
Measured in 4.4.2 and 4.9.2
Tangent of loss angle:
Measured initially in C1A and C1B
4.11.2 Dry heat Temperature: 110 °C
4.11.3 Damp heat cyclic
Test Db
First cycle
Duration: 16 h
4.11.4 Cold Temperature: - 55 °C
4.11.5 Damp heat cyclic
Test Db
remaining cycles
Duration: 2 h
4.11.6 Final measurements Visual examination No visible damage
Legible marking
Capacitance |C/C|  5 % of the value measured in 4.11.1.
Tangent of loss angle Increase of tan :
 0.008 for: C  1 µF or
 0.005 for: C > 1 µF
Compared to values measured in 4.11.1.
Voltage proof
1350 V
DC
; 1 min between terminations
No permanent breakdown or flash-over

Insulation resistance  50 % of values specified in section “Insulation
resistance” of this specification
SUB GROUP C2
4.12 Damp heat steady state 56 days, 40 °C, 90 % to 95 % RH
No load
4.12.1 Initial measurements Capacitance
Tangent of loss angle at 1 kHz
GROUP C INSPECTION REQUIREMENTS
SUB-CLAUSE NUMBER AND TEST CONDITIONS PERFORMANCE REQUIREMENTS