Data Sheet

MKP336 2 X2
www.vishay.com
Vishay BCcomponents
Not for New Designs - Alternative Device: MKP339 X2
Revision: 25-Jul-2019
14
Document Number: 28120
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
SUB-GROUP C4
4.15.1 Initial measurements Capacitance
Tangent of loss angle:
For C  1 µF at 10 kHz
For C > 1 µF at 1 kHz
4.15.3 Final measurements Capacitance |C/C|  10 % compared to values measured in
4.15.1.
Tangent of loss angle Increase of tan :
 0.008 for: C  1 µF or
 0.005 for: C > 1 µF
Compared to values measured in 4.15.1.
Insulation resistance  50 % of values specified in section “Insulation
resistance” of this specification
SUB-GROUP C5
4.16 Radio frequency
characteristic
Resonance frequency  0.9 times the value as specified in section
“Resonant frequency” of this specification
SUB-GROUP C6
4.17 Passive flammability
Class B
Bore of gas jet: Ø 0.5 mm
Fuel: Butane
Test duration for actual volume V in mm:
V  250: 10 s
250 < V  500: 20 s
500 < V  1750: 30 s
V > 1750: 60 s
One flame application
After removing test flame from capacitor, the
capacitor must not continue to burn for more
than 10 s. No burning particle must drop from
the sample.
SUB-GROUP C7
4.18 Active flammability 20 cycles of 2.5 kV discharges on the test
capacitor connected to U
RAC
.
The cheese cloth around the capacitors shall
not burn with a flame.
No electrical measurements are required.
GROUP C INSPECTION REQUIREMENTS
SUB-CLAUSE NUMBER AND TEST CONDITIONS PERFORMANCE REQUIREMENTS
45.0°
~ 8 mm
12 mm