User's Manual Part 1

Specifications - 19 -
®
Affinity LBD-200C-N1 Transmitter
Product Manual
Rear Panel Remote Serial Monitoring and Control Interface
Serial Network Communications
Protocol
TNET Thales proprietary
Electrical Interface RS485 4-wire full duplex (remote bus)
Daisy chain connection, last device in
chain requires termination
Interface Connectors (2) RJ11 connectors NET interface on rear panel
Rear Panel Local Serial Monitoring and Control Interface
Serial Network Communications
Protocol
TNET Thales proprietary
Electrical Interface RS485 4-wire full duplex (local bus)
Interface Connector RJ11 connector J3 connector of rear panel
Rear Panel Agile controller interface
Electrical Interface TTL logic
Provides critical TX status and
controls for use with Thales agile
back-up and control system (ABCS),
for N+1 system configurations
Interface Connector RJ11 connector J2 connector of rear panel
Rear Panel ABCS interface
Electrical Interface TTL logic
Interface Connector Male 15-pin D-sub connector
J4 connector of rear panel; used for
ABCS command of the designated
Agile UCA unit.
Rear Panel modulator interface
Serial Network Communications
Protocol
OPT 1 Thales proprietary
OPT 2 UBS/ProTel proprietary
Used to interface TX to Thales or
OEM (UBS/Protel) Modulator; offers
limited command and status of OEM
modulator.
Electrical Interface RS232 2-wire full duplex
Interface Connector Male 9-pin D-sub connector J6 connector of rear panel
Rear Panel PAS Command
Serial Network Communications
Protocol
TNET Thales proprietary
Electrical Interface
RS485 4-wire full duplex (local bus) +
PAS standby & reset
Interface Connector Female 9-pin D-sub connector J7 connector of rear panel