User's Manual Part 1

Safety - 3 -
®
Affinity LBD-200C-N1 Transmitter
Product Manual
3 Safety Information
3.1 Introduction
The Thales Broadcast & Multimedia Affinity® transmitter conforms to the safety information
contained in the International Electrotechnical Commission (IEC) publication 60215 (1987-06)
(www.iec.ch
). The design and manufacturing approach of the transmitter will protect the
operator from dangerous voltages, heat, radiation, and other hazards if operated within the
confines of the specification. Thales has attached warning labels to the enclosures and/or
various assemblies to identify potentially dangerous conditions to the operator. Operators must
adhere to these warning labels.
Thales recommends that only skilled personnel, as defined by the IEC 60215 publication, be
permitted to operate the transmitter. Proper training and correct equipment operation will
remove the risk of hazardous conditions and dangers to the operator.
3.2 Warnings, Cautions, and Notes
This manual contains WARNING and CAUTION notices that identify procedures, conditions,
and materials that could potentially cause death, injury, or damage to equipment.
A WARNING notice will appear before a procedure or instruction if injury or death could result
from performing the procedure or instruction incorrectly.
A CAUTION notice will appear before a procedure or instruction if equipment damage could
occur from performing the procedure or instruction incorrectly.
A NOTE appears after a paragraph to highlight important information.
WARNING
This equipment uses dangerous voltages that
can cause injury or death. Observe applicable
safety precautions.
CAUTION
Do not operate the transmitter with the antenna
and station-load disconnected. Doing so may
damage the transmitter.
Warning and Caution Samples
NOTE: The RF Sample contains pre-distortion and is not representative of output signal. The
RF sample is a reference point for testing only.
Note Sample