Manual

3
Note
The functions described in this section are only available for
Bluetooth
®
-capable terminal devices.
5.1. Bluetooth® pairing
Note – Pairing
• Make sure that your Bluetooth
®
-capable terminal device
is on and Bluetooth
®
is activated.
• Make sure that your Bluetooth
®
-capable terminal device
is visible for other Bluetooth
®
devices.
• For more information, please refer to the operating
instructions of your terminal device.
• The headset and the terminal device should not be any
further than 1 metre away from each other. The smaller the
distance, the better.
• Switch the headset on using the MF button (5).
• Press and hold the MF button (5) until the red and blue LEDs
ash alternatingly and a voice says „Pairing“.
• The headset is searching for a Bluetooth
®
connection.
• Open the Bluetooth
®
settings on your terminal device and
wait until Thomson WEAR 7208 appears in the list of
Bluetooth
®
devices found.
• Select Thomson WEAR 7208 and wait until the headset
is listed as connected in the Bluetooth
®
settings on your
terminal device.
Note – Bluetooth® password
Some terminal devices require a password in order to
connect to another Bluetooth
®
device.
• If your terminal device requests a password for
connection with the headset, enter 0000.
Note
• Once the connection has been established, a voice says,
“Connected”.
• If the connection attempt takes longer than 300 seconds
to complete, it is cancelled and the LEDs go out.
In this case, repeat the steps listed previously under 5.1
Bluetooth
®
pairing.
5.2. Automatic Bluetooth
®
connection (after successful
pairing)
Note
• Make sure that your Bluetooth
®
-capable terminal device
is on and Bluetooth
®
is activated.
• Make sure that your Bluetooth
®
-capable terminal device
is visible for other Bluetooth
®
devices.
• For more information, please refer to the operating
instructions of your terminal device.
• Switch the headset on using the MF button (5). The blue LED
begins to ash and the headset automatically connects with
the last terminal device used.
• A successful connection is signalized by the announcement
(Connected)
Note
• Once the connection has been established, a voice says,
“Connected”.
• If the connection attempt takes longer than 300 seconds
to complete, it is cancelled and the LEDs go out. In this
case, repeat the steps listed previously under 5.2.
• It may be necessary to make settings on your terminal
device to enable automatic connection with the paired
headset.
Note – Connection impaired
After the headset and terminal device have been paired,
a connection is established automatically. If the Bluetooth
®
connection is not established automatically, check the
following:
• Check the Bluetooth
®
settings of your terminal device to
see whether Thomson WEAR 7208 is connected. If not,
repeat the steps listed under 5.1. Bluetooth
®
pairing.
• Check whether obstacles are impairing the range. If so,
move the devices closer together.
• The performance can also be affected by a weak battery.