User's Manual

• Ensure the battery pack is installed correctly.

• The handset should beep when you press the TALK button and the charge

indicator on the base should be lit when the handset rests in the cradle. If not,

the battery may need to be charged.

• Place handset in charge cradle for at least 20 seconds to reset the unit.

Handset does not ring

• Make sure the handset ringer switch is turned ON, this can be done through the

handset setup menu - Ringer Volume.

• The handset may be out of range. Move closer to the base.

• You may have enabled Do Not Disturb (DND). Make sure the DND is off.

• You may have too many extension phones on your line. Try unplugging some

phones.

• Check for dial tone.

You experience static, noise, or fading in and out

• The handset may be out of range of the base. Move closer to the base.

• Make sure base is not plugged into an outlet with another household appliance.

If necessary, relocate the base.

• Charge the battery.

Unit beeps

• Clean charging contacts on cordless handset.

• See solutions for “No dial tone”.

• Replace the battery.

Memory Dialing doesn’t work

• Did you program the memory location keys correctly?

• Did you follow proper dialing sequence?

Unit locks up and there is no communication between the base and cordless handset

• Unplug the AC power adaptor from the wall outlet and the back of the base.

Remove the handset battery. Wait for 30 seconds and plug the power adaptor

back into the base and wall outlet. Reconnect the battery and charge for 16 hours.