Operation Manual

EN
7
English
Important:
Batteries shall not be exposed to excessive heat such as sunshine, re or the like. Remove batteries when the remote
control is not to be used for a long time. Batteries left in equipment may cause damage through deterioration and
corrosive leakage, invalidating the guarantee.
To protect the environment use local recycling facilities for battery disposal. Dispose of used batteries according to the
instructions.
CAUTION:
Risk of explosion if batteries are replaced by an incorrect type. Replace only with the same or equivalent
type recommended by the equipment manufacturer.
If the batteries in your remote control are run down, you can use the buttons on your TV set. In TV mode, they have
the same functions as the corresponding buttons on the remote control. The OK button on the TV set can be pressed
repeatedly to select the required source. In the menus they have the following functions:
For models with
OK
button on the set: For models without
OK
button on the set:
PR+
or
PR ▲
▲
PR+
or
PR ▲
►
PR-
or
PR ▼
▼
PR-
or
PR ▼
◄ &
OK
VOL+, +
or
VOL ►
►
VOL+, +
or
VOL ►
▲
VOL-, -
or
VOL ◄
◄
VOL-, -
or
VOL ◄
▼
MENU
or
MENU MENU
or
MENU
OK OK
Getting started
Switch the TV on and off
1.
When the power cord is connected, the TV will be turned on directly or be in standby mode. If the TV is in
standby mode, press the or
POWER/
button on the set or the button on the remote control to turn it
on.
2.
To put the TV into standby mode, press the or
POWER/
button on the set or the button on the remote
control. The TV set remains powered up, but with low energy consumption.
3.
To switch the TV off, unplug the mains plug from the mains outlet.
(*On certain models, you have to turn on the power switch rst.)