Operation Manual

ST2030s VoIP Business Phone
ST2030s SIP Administrator Guide v3.0 Page 125 of 308
New Implementation
A new parameter in Common and MAC configuration files is added to
increase the flexibility to assign the [Transf] softkey on ringing shown in MMI
with/without respect to the call forward bit in parameter “OptionVisible”
accordingly.
TransfOnRingFlag =<0/1>, 0 is disable (by default), 1 is enable
TransfOnRingFlag = 0, [Transf] softkey is always enable without respect to
the
call forward bit in parameter “OptionVisible.
TransfOnRingFlag = 1, [Transf] softkey with respect to the call forward bit in
parameter “OptionVisible” enable/disable. (Same as
the
current implementation above)
Table below describes the Enable/Disable of the [Transf] softkey on Ringing
with Call forward bit in “OptionVisible”.
Call forward bit in
“OptionVisible” = 0
Call forward bit in
“OptionVisible” = 1
TransfOnRingFlag = 0
Enable
Enable
TransfOnRingFlag = 1
Disable
Enable
Feature Activation
A new parameter is needed to configure this function and with some
additional definitions listed below.
[Transf] softkey enable/disable on ringing in
MMI is directly followed the activation /
deactivation of callforward bit accordingly.