Operation Manual

1 8
NOTE:
1. The washing time may vary depending on the incoming water temperature and the
ambient temperature.
2. The power consumption in left-on mode is 0.49W (door open), in off-mode it is 0.45W.
Starting the Dishwasher
1. Turn the water tap on.
2. Open the dishwasher door.
3. Check the filters.
 Ensure they are clean and properly positioned. See “Cleaning and maintenance”
section.
4. Check that there is rinse aid and salt.
5. Load the dishes.
 Ensure that the spray arms can rotate freely.
6. Add the required amount of detergent into the dispenser according to the “Washing
Programmes” chart.
7. Press to switch on the dishwasher.
8. Select the desired washing programme by repeatedly pressing P.
 The corresponding programme indicator light will illuminate on the display.
 Delay timer: The delay timer allows you to delay the start of a washing programme
from 1 hour to a maximum of 24 hours.
Repeatedly press until the desired start delay time is shown on the display, e.g.
H:03 for a 3-hour delay.
Once the delay timer has been set, close the door to activate the function.
To cancel the delayed start, repeatedly press until the display shows “H:00”.
9. If you want to activate extra dry or express function, repeatedly press until the
desired function indicator light illuminates.
 The extra dry function can only be used with the Intensive, Normal, Eco,
Glass and 90 min programmes. When this function is activated, the dishwasher
will increase temperature at the end of a washing programme to improve drying.
 The express function can only be used with the Intensive, Normal, Eco,
Glass and 90 min programmes. When this function is activated, the dishwasher
will reduce the running time while slightly increasing water and energy
consumption.
Downloaded from www.vandenborre.be