Operation Manual

P14
MAIN MENU
Use tu to switch between Left and Right window. (Satellite List and Transponder List.)
Add: While in the satellite name list: Press YELLOW to add a new satellite. In
the popup window, enter a satellite name with the key table (press u),
selecting a character by using the navigation buttons. Press OK to enter
the chosen character. When you have entered the name, navigate to the
 on screen and press OK on the remote control to confirm the new
name. Select the satellites position E for East and W for West. Longitude:
Use the numeric keys to enter the longitude of the satellite. Save the
settings with OK or cancel with EXIT.
While in the Transponder list: Press YELLOW to add a new Transponder. In
the popup window enter the frequency, symbol rate and polarity of the
new transponder.
Delete While in the satellite name list: Press BLUE to delete a satellite from the list.
Press GREEN to delete the selected satellite, select YELLOW to delete all
satellites. Confirm deleting with OK or EXIT to cancel.
While in the Transponder list: Press BLUE to delete a transponder from the
list. Press GREEN to delete the selected transponder, select YELLOW to
delete all transponders. Confirm deleting with OK or EXIT to cancel.
Edit: While in the satellite name list: Press RED Edit to enter the Sat Edit window.
Select the satellites position E for East and W for West. Longitude: Use the
numeric keys to enter the longitude of the satellite. Enter a satellite name
with the key table (press u), selecting a character by using the navigation
buttons. Press OK to enter the chosen character. When you have entered
the name, navigate to the  on screen and press OK on the remote
control to confirm the new name. Save the settings with OK or cancel by
EXIT.
While in the Transponder list: Press RED Edit to enter the TP Edit window.
Frequency: Use the numeric keys to enter a known frequency of the
satellite transponder. Symbol Rate: Use the 0~9 buttons to enter the
symbol rate of the satellite transponder.
Polarity: Press tu to select the polarization of the satellite transponder. V
(Vertical) or H (Horizontal).
After entering all data, press OK and conrm with OK or press EXIT to leave without saving.
Use GREEN to enter to the Automatic scan window.
NOTE: Deleted satellites and transponders from the pre-installed lists can only be
retrieved by performing a factory reset.
7.1.4 Automatic SAT scan
Select the options if you want to do automatic scan.
Satellite: Select the satellite you wish to scan, as previously set up in the Satellite
Setting menu.
Transponder: Select a transponder which is known to carry a signal to check if reception
of the satellite is possible.