Operation Manual

GB
BUILT-IN INSTALLATION
This appliance is designed to be built into a cabinet by referring to the dimensions shown below.
8
2
5
mm
600mm
825mm
5
4
0m
m
595mm
152.5mm
17.5mm
580mm
When installing the appliance into the cabinet, if possible, place the hoses in either of the two
recesses on the back of the appliance. This will help to prevent the hoses from becoming kinked
or trapped.
Level the appliance by raising or lowering the feet.
Loosen the lock nut using a spanner (not supplied) and turn the foot
by hand until it contacts the floor.
Hold the foot with one hand and fasten the nut against the cabinet
with a spanner.
Never put cartons, wooden blocks or similar materials under the
machine to balance the irregularities on the level of the ground.
Accurate levelling prevents vibration, noise and displacement of the appliance during operation.
Fittings
Type-A screw (x8) Type-B screw (x6)
Hinge (x2)
Magnet plate (x2)
Spacer (x2)
Drilling template (x1)
30
Downloaded from www.vandenborre.be