Use and Care Manual

Step 3
For the flame ring base part. make sure that
the electrode will go through the hole on the
10 o’clock position. Make sure the electrode
is not going through the hole next to the
cross-over.
Step 4
Make sure the electrode is vertical to the
surface of the burner base. Please be
notified that there’s a slot at the 8 o’clock
position of the burner base. This slot helps to
locate the burner base.
Here’s the procedure to have Customer/Servicer check the condition for our current
burner design. The procedure helps the electrode to sense the flame correctly:
53