Use and Care Manual

Procedure for Checking the Dual Burner Clicking Problem

20. Procedure for Checking the Dual Burner

Clicking Problem

Here’s the procedure to have Customer/Servicer check the condition for our current burner design.

The procedure helps the electrode to sense the flame correctly:

Step 1

Make sure the Burner Design is correct. Our current

design for the burner is has the electrode on the left

side (10 o’clock) and cross-over on the right side (2

o’clock).

There are four parts for the dual burners.

They are burner cap, flame ring base, flame ring and

burner base.

Step 2

Make sure the electrode is going through the hole on

the flame ring and it is vertical to the surface of flame

ring base.