Range Hood Installation Guide and User Manual This manual applies to: HRH3001U HRH3002U HRH3005U HRH3006U HRH3601U HRH3602U HRH3605U HRH3606U HRH4801U HRH4802U HRH4805U HRH4806U HRH3009-BS HRH3609-BS HRH4809-BS CRH3001U CRH3601U CRH4801U TKH3001U TKH3601U TKH4801U
Safety Notice Your Thor Kitchen Range hood is designed and approved for residential use only. The warranty will be void if apply for commercial use. Please read instructions completely before starting. The installation of the appliance must apply to local codes. Important: Save instruction so that it may be provided to your installer in your local area. Safety Warning: Turn off the circuit breaker at your electrical panel before connecting to a power source. Power requirement: 110V-120V/60HZ.
TO AVOID INJURIES IN A GREASE FIRE, PLEASE FOLLOW THE FOLLOWING: 1. Put out the fire with a lid according dimension of the cooking pot, or baking & cookie sheet or other metal tray, then turn off the gas or power supply of the stove. If the flames do not go out immediately, CALL THE FIRE DEPARTMENT IMMEDIATELY. 2. DO NOT USE WATER TO PUT OUT FIRE ON A RANGE, including wet dish towels. 3. Use an extinguisher only if: 3.1 Make sure to have a Class ABC extinguisher; 3.
Electrical Requirements and Installation Requirements Power Requirements IMPORTANT: Please review all local area installation codes. The customer is responsible for: Contacting a certified installer, checking that the electrical installation is adequate and is in accordance with the National Electrical Code, ANSI / NFPA 70 (or latest edition *) or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 (the latest edition **) of the CSA, and all codes and ordinances in your area.
Size for Venting Duct Follow the guidelines presented in this manual. Ventilation methods: You might be having a 67/8 inches (in certain models or 75/8 inches) duct size for your Thor Kitchen Range Hood. Recommended duct size for your range hood will be: Model Number Duct Size Recommended Size for Duct Pipe 01, 02, 04, 06, 06-BS series 67/8 inches 7”-8” 05 series 75/8 inches 8”-9” ***Any Reduction of duct pipe size will affect the performance of the range hood and cause potential noise issue.
Clearance Caution: Before installation, inspect the maximum height of your ceiling, Check the distance between the bottom of the range hood and the countertop of your cooking appliance. The required distance from the countertop of range top/ cook top to your Thor Kitchen Range hood should be between 27” to 30”. For clearance more than 30”, it will affect the efficiency of the hood.
Installation 1. Open-box Check Open the box for your Thor Kitchen Range hood, Locate power cord, mounting plate (2 pcs for certain designs), screw sets, filters (2pcs for 30-inch and 36-inch range hood, 3 pcs for 48-inch range hood), small filters (2 pcs for all designs) and grease tray (1 pc) inside the box. You should also have a template showing the back layout of your range hood, including mounting plate and mounting screws.
(2) Drywall Screw set (b) and (c) are used for securing range hood (mounting plate) to the wall. • It’s required that holding plate (mounting plate) needs to be anchored in studs – the wall alone will not be strong enough to support range hood’s weight. The center of a stud provides the best support for the range hood. At least one Drywall Screw set needs to be mounted into stud. Use stud Finder to locate the stud before mounting the drywall screw set to the wall.
5. Duct Pipe Sealing Use duct sealing tape to connect duct pipe to the hood duct. Avoid reducing for the duct pipe size or it will affect hood performance. • We provide a 67/8 inches (in certain models 75/8 inches) duct size for your Thor Kitchen Range Hood. Recommended duct size for your range hood is shown below: Model Number Duct Size Recommended Size for Duct Pipe 01, 02, 04, 06, 06-BS series 67/8 inches 7”-8” 05 series 75/8 inches 8”-9” 6.
8. Filter handle Installation Your Thor Kitchen Range Hood might have a KD design handle. 9. For Ceiling pipe If the duct vents to the top ceiling: • Use a pencil to draw a vertical line from the center of the template to the top ceiling; • Make sure there’s at least 4” clearance from the back wall to the top ceiling where the hood duct is located, and the size of the hood duct on top ceiling should be no less than 71/2” (81/2” for 05 series range hood). 10.
Tools for Installation 10
Range Hood Spec 01 series / CRH Series Range Hood 11
02 series /TKH Series Range Hood 12
05 series 30-inch and 36-inch range hood 13
05 series 48-inch range hood 14
06 series 30-inch and 36-inch range hood 15
06 series 48-inch range hood 16
09 BS (black stainless steel) series range hood 17
HRH-01 series / CRH series range hood operating instruction Control Buttons/ Indicators: A0 button: Remote control signal lamp A1 button: Power( on/off) A2 button: LED bulb A3 button: Display LCD screen A4 button: Time Delay. A5 button: Low speed A6 button: High speed A4 button is equipped with a maximum of 15-minute time delay function, A1 button( on/off) control to directly started or off. Turn on the fan: Keep your hood ventilating during the cooking. Press A1 button, then A3 display screen is active.
HRH-02 series, HRH-05 series, HRH-06 series HRH-09 series and TKH range hood operating instruction: Control buttons/indicators: F1 button/indicator (blue): LED light button F2 button/indicator (blue): low speed F3 button/indicator (blue): medium speed F4 button/indicator (blue) : high speed F5 button/indicator (red): time-delay or power on/off Turn on the fan: - Keep your hood ventilating during cooking.
Maintenance WARNING Before servicing or cleaning unit, switch power off at service panel and lock access panel to prevent it from being switched on accidentally. If the power panel cannot be locked, place a warning device, such as a brightly colored label. Grease filters The grease filters should be cleaned once a month or as needed. To remove grease filter, pull the metal latch down. This will disengage the filter hood. Tilt the filter down, then remove.
Warranty & Service This product has been manufactured by Thor Group, 13831 Oaks Avenue Chino, CA 91710. Thor Group disclaims all express warranties except for the following: This warranty applies to products purchased and located in the United States. Products purchased or located outside this area are excluded.
coverage. 7. The removal and re-installation of your Thor Kitchen product if it is installed in an inaccessible location or is not installed in accordance with published installation instructions. 8. This warranty is void if the factory applied serial number has been altered or removed from your Thor Kitchen product. 9. Repairs to parts or systems resulting from unauthorized modifications made to the appliance. 10.
