INSTRUCTION MANUAL HWC2405U 1
TABLE OF CONTENTS Contents ● ● Page# wine Cooler package Contents 3 Important Safety Instructions 3 Main structure of Product 4 Installation 5 Temperature setting 6 Points of intentions 7 Product parameters 7 Layout and storage 7 Care and maintenance 8 Troubleshooting guide 10 Warranty 11 2
● Wine Cooler package Contents Instruction Manual 6 Standard Shelves ● Important Safety Instructions WARNING: To reduce the risk of fire, electric shock or personal injury , disconnect the appliance from the power supply before servicing. unplug or Read all instructions before using the wine cooler. DANGER: Risk of child becoming trapped in new wine cooler, old wine cooler/refrigeration unit, or large boxes.
Main Structure Of Product ① Cabinet ② Tempered glass door ③ Stainless steel handle ④ Ventilator ⑤ Leveling leg ⑥ Control panel ⑦ Fan ⑧ Return-airway ⑨ Shelves ⑩ Lock 4
Installation Install handle 1. Remove the door gasket on the side you wish to install the handle – you can see two designated holes for handle installation. 2. Install the handle tightly as shown above with two screws, lock washers and flat washers provided. 3. Replace the door gasket. Install the wine cooler: Your product has been designed built-in or free standing installation.
Attention: The ventilator should not be covered, or it will cause unpredictable breakdown; the fan and the return-airway should not be covered, too, or it will cause the temperature of the wine cooler couldn’t reach the setting temperature, and the temperature of the cabinet is uneven.
Temperature Setting The setting should be operate in the control panel. （1）Functions of each keys in the control panel. ①Up Used to raise (warm)the set temperature by 1℃ or 1℉. When number “3” is flashing, press it once, the temperature setting is up by 1℃ or 1℉, the highest setting temperature is 10℃(50F). ②Down Used to lower (cool) the set temperature by 1℃ or 1℉. When number “3” is flashing, press it once, the temperature setting is down by 1℃ or 1℉, the highest setting temperature is -2℃（28F）.
（2）There is automatic storage memory when power off in this wine cooler, that means the setting temperature is memories automatically even in power off, so the setting temperature is the same as last setting when the wine cooler is running again. （3）Defrosting The unit defrosts automatically. The evaporator behind the rear wall of the unit defrosts automatically.
You can crease your wine cooler storage capacity by removing shelves and stacking bottles on top of one another. Do not stack more than 3 rows of bottles per shelf. ●Care Maintenance Cleaning your wine cooler Turn off the power, unplug the appliance, and remove all items including shelves and rack. Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a pint of water. Wash the shelves with a mild detergent solution.
The Wine Cooler should be located in the coolest area of the room, away from heat producing appliances, and out of the direct sunlight. Ensure that the unit is adequately ventilated. Never cover air vents. Only open the door for as long as necessary. ●Troubleshooting Guide Problems with Your Wine Cooler Many common issues with your wine cooler can be solved very easily. Try the troubleshooting tips below should you experience any problems. PROBLEM POSSIBLE CAUSE Wine Cooler does not operate.
●Warranty This product has been manufactured by Thor Group, 13831 Oaks Ave, Chino, California 91710. Thor Group disclaims all express warranties except for the following: This warranty applies to products purchased and located in the United States. Products purchased or located outside this area are excluded.
5. Damage resulting from misuse, alteration, accident, abuse, fire, flood, acts of God, improper installation, installation not in accordance with electrical, or use of consumables or cleaning products not approved by Thor Group. 6. Service to repair or replace consumable parts. Consumable parts are not included in the warranty coverage. 7.
