TABLE OF CONTENTS Contents ____________________Page # Wine Cellar Package Contents 3 Important Safety & Pre-Use Instructions 3 Installation Instructions 3 Built In Installation 4 Operating Your Wine Cellar 4 Temperature Settings 4 Layout & Storage 5 Care & Maintenance 5 Troubleshooting Guide 7 Technical Information 8 2
Wine Cellar Package Contents Instruction manual 12 Standard Shelves IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock, or injury when WARNING using your appliance, follow these basic precautions: Read all instructions before using the wine cellar. DANGER: Risk of child becoming trapped in new cellar, old wine cellar/refrigeration unit, or large boxes.
Built In Application. Your wine cellar can be installed built into cabinetry. The minimum dimensions of the built in area are as follows: 24 ½” W X 26 ½” D X 34” H Operating Your Wine Cellar Setting the Temperature Control/Display panel Temperature Control Control Panel at Left Zone To turn the appliance ON or OFF, touch simultaneously for 5 seconds. Turns the left zone light ON or OFF. Increases the left zone temperature by 1°C or 1°F. Decreases the left zone temperature by 1°C or 1°F.
Increases the right zone temperature by 1°C or 1°F. Decreases the right zone temperature by 1°C or 1°F. TEMPERATURE SETTINGS FOR SERVING WINE Although optimal storage temperature is generally regarded to be 53-57°F, different varietals of wine require different service temperature settings. The recommended temperature ranges for serving different varietals of wine are listed below. Your wine cellar will indicate when you have set the Upper/Lower zones to the below temperature ranges.
Power Loss Power failures that are corrected within a few hours should not affect the temperature of your appliance if you minimize the number of times the door is opened. If the power is going to be off for a longer period of time, you need to take other measures to protect your contents. If the unit is unplugged, loses power, or is turned off, you must wait 3 to 5 minutes before restarting.
TROUBLESHOOTING GUIDE Many common issues with your wine cellar can be solved very easily. Try the troubleshooting tips below should you experience any problems. PROBLEM Wine cellar does not operate. POSSIBLE CAUSE Not plugged in. The appliance is turned off. The circuit breaker tripped or a fuse has blown out. Wine cellar is not cold enough. Check the temperature control setting. External environment may require a higher setting. (e.g. room needs to be air conditioned) The door is opened too often.
TECHNICAL DATA Model Number JC-116A2EQ Accommodation 36 bottles (bottles) Wine Cellar Dimension 23 ½” W X 24 ½” D X 34” H Type of cooling Compressor cooling Climate type N Electricity protection grade I Nominal voltage/Frequency 115V/60HZ Rated power(W) 100 Watts 60-77 degrees Fahrenheit Ambient temperature Temperature range 40-72F Range of inside cabinet humidity 60%RH 8