TABLE OF CONTENTS Contents ____________________Page # Wine Cellar Package Contents 3 Important Safety & Pre-Use Instructions 3 Installation Instructions 3 Built In Installation 4 Reversing Door Swing 4 Operating Your Wine Cellar 4 Temperature Settings 4 Layout & Storage 5 Care & Maintenance 6 Troubleshooting Guide 7 Technical Information 8 2
Wine Cellar Package Contents Instruction manual 6 Standard Shelves IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock, or injury when WARNING using your appliance, follow these basic precautions: Read all instructions before using the wine cellar. DANGER: Risk of child becoming trapped in new cellar, old wine cellar/refrigeration unit, or large boxes.
Built In Application. Your wine cellar can be installed built into cabinetry. The minimum dimensions of the built in area are as follows: 24 ½” W X 26 ½” D X 34” H Door Swing Your wine cellar was shipped from the factory with the door opening from left to right. If necessary, you can reverse the door opening direction from right to left by following these steps: 1. Remove the upper hinge by prying up the hinge cap and removing the screws holding the hinge in place. 2. Lift the door off the bottom hinge.
Decreases the temperature by 1°C or 1°F. The temperature display can be shown in either Fahrenheit or Celsius. To change the temperature display press and hold for 5 seconds. Temperature reading of lower zone Temperature reading of upper zone SETTING A TEMPERATURE Press to select either the upper or lower temperature zone. Press or to increase or decrease the temperature. The upper zone and the lower zone can be set to a temperature between 40-72° F.
CARE AND MAINTENANCE Cleaning Your Wine Cellar. Turn off the power, unplug the appliance, and remove all items including all shelves. Wash the inside surfaces with a solution of warm water and baking soda (approximately 2 tablespoons of baking soda for each quart of water.) Wash the shelves with a mild detergent solution. Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.
TROUBLESHOOTING GUIDE Many common issues with your wine cellar can be solved very easily. Try the troubleshooting tips below should you experience any problems. PROBLEM Wine cellar does not operate. POSSIBLE CAUSE Not plugged in. The appliance is turned off. The circuit breaker tripped or a fuse has blown out. Wine cellar is not cold enough. Check the temperature control setting. External environment may require a higher setting. (e.g. room needs to be air conditioned) The door is opened too often.
TECHNICAL DATA Model Number JC-145A2EQ Accommodation 46 bottles (bottles) Wine Cellar Dimension 23 ½” W X 24 ½” D X 34” H Type of cooling Compressor cooling Climate type N Electricity protection grade I Nominal voltage/Frequency 115V/60HZ Rated power(W) 100 Watts 60-77 degrees Fahrenheit Ambient temperature Temperature range 40-72F Range of inside cabinet humidity 60%RH 8