Manual

7
INSTALLATION INSTRUCTIONS
 BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
Model TBC2401DI
1 Instruction Manual
6 Wooden Shelves with Rolling Slideways
3 Black Wire Shelves
2 Door Handles
• Before connecting this appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling
system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
 INSTALLATION OF YOUR APPLIANCE
•
This appliance is designed for free standing
installation or built-in (fully recessed).
• Place your appliance on a floor that is strong enough to support it when it is fully loaded. To
level your appliance, adjust the front leveling legs at the bottom of the appliance.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
• Avoid locating the unit in moist areas.
• Plug the appliance into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or a
service center authorized by Thor Group.
 BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing installation. If you plan to use this unit in
a built-
in application, please follow the requirements shown below.
Cabinet Opening Dimensions
IN (min) CM (min
)
Width
23 4/5”
60.5 cm
Depth 24” 61.0 cm
Height 34 1/2” 87.6 cm
>24"(610mm)
2
2
"
3 / "
34
/

2
"(876mm)
1
23 "
½
23 "
4
/
33 / "
/
8
34 "
/
¼
>23 "
5
(605mm)
4
/
3
1
8
5