TGC3601 | TGC3001 TGC MODELS COOK LIKE A GOD USE AND CARE MANUAL
USE AND CARE MANUAL PROFESSIONAL DROP-IN GAS COOKTOP TGC MODELS TGC3601 | TGC3001
Contents Important safety information 3 Stainless steel surfaces 19 WARNING: If the information in this manual is not followed exactly,a fire Overview 10 Control knobs 19 or explosion may result causing property damage, personal injury, or death.
Important safety information Read all instructions before using this appliance · All electrical and gas equipment with moving parts can be dangerous. Please read the important safety instructions for this appliance in this manual. The instructions must be followed to minimize the risk of injury, death, or property damage. ·Save this manual. Please Do Not Discard.
Fire safety ! WARNING To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following precautions. · Do not store, place, or use flammable or combustible materials such as paper,plastic, pot holders, linens curtains, gasoline or other flammable vapors or liquids near the cooktop. · Do not wear loose fitting or hanging garments while using the cooktop. · To avoid grease buildup, regularly clean the vents.
Installation safety Location safety Cooktop safety ! ! ! WARNING To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following precautions. · Have your cooktop installed and properly grounded by a qualified installer, in accordance with the installation instructions. Any adjustment and service should be performed only by qualified gas cooktop installers or service technicians.
Overview · Before removing or changing cookware, turn off the burners. Dimension and clearance · Remove food and cookware immediately after cooking. · Before removing any parts of the burner for cleaning, make sure the cooktop is off and completely cool. 30" /36”Model:TGC3001/TGC3601 · After cleaning the burner spreader, make sure it is completely dry before re-assembling. · To avoid carbon monoxide poisoning, do not pour water into the cooktop well while cleaning.
TGC3001 Circuit Diagram K1 G1 D1 LED1 G Right Front K2 G2 CN5 D2 CN6 LED5 HW-ZB-1460-01 LED4 18" INPUT:AC 120V BLACK(L) WHITE(N) GREEN(PE) Plug AC M ale - 11- TGC3601: Cut Out Dimension TGC3001&TGC3601 Gas Cooktop Clearance PE N L COS1 S2 S3 2 1 HV4 HV5 HV6 SW5 SW6 LR SW4 SW3 RR HV3 SW2 HV1 RF 24" 610mm CO N 4" SW1 4" L CHANNEL Pluse igniter 2.5" (63.5mm) TGC3001 Cut Out Dimension 2 Left Rear ( 457mm) LF 2.5" (63.
TGC3601 CircuitDiagram K1 G1 What’s included D1 LED6 G Right Front K2 CN5 D2 G2 CN6 LED5 1 2 3 4 5 6 78 CN6 D3 G3 CN5 CN4 CN7 K3 1 23 4 1 23 Middle Front 1 2 3 4 5 6 78 G LED4 G HW-ZB-1460-01 D4 LED3 G CN1 1 2 G4 CN12 K4 CN1 LED Power board 100 X60mm 1 2 Left Front Right Rear K5 D5 G5 LR CR RR LF RF CF LED2 G INPUT:AC 120V PE BLA CK(L) WHITE(N) GREEN(PE) HV2 HV3 HV4 HV5 HV6 SW3 SW4 SW5 SW6 COS1 HV1 L SW2 N SW1 Left Rear CO D6 LED1 L G6 G
ELECTRICAL REQUIREMENTS Using the cooktop burners To light a burner: 1. Your cooktop equip with an automatic ignition system and Thor Kitchen Gas cooktop requires 110 volts, 50/60 Hz electrical supply to operate the ignition system. ! WARNING Electrical Grounding InstructionsThis appliance is equipped with a (three-prong)(four-prong) grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle.
Cookware Requirements Install the grates Wok Ring ·Flat bottom and straight sides ·Tight-fitting lid ·Well-balanced with the handle weighing less than the main portion of the pot or pan. Install the grates as instructed below for longest life. Woks are often used for stir frying, pan frying, deep frying, and poaching. The provided wok ring supports 12” to 14” woks 1. Turn off all burners, and wait until the grates completely cool down. 2. Place the wok ring on any grate. 3. Put a wok on the wok ring.
Stainless steel surfaces Control knobs Burner grates and components 1. Do not remove any spills, spots, and grease stains using Make sure all surface burner knobs are in OFF position. Turn off all surface burners and make sure they have 1.Grasp each knob and pull straight up to remove all cooled down. 2.Clean the knobs with soft cloth and warm, soapy water. 1. Remove the burner grates. Then rinse and dry them thoroughly. 2. Remove the burner caps from the burner heads. and location.
Burner bases 心CA UTION The burner bases cannot be removed for cleaning. Make sure NOTE Burner head and cap replacement Burner cap Round Burner head 1.Match the burner caps to the burners by size, and then re-install the caps on the bu「ner heads. Do not attempt to remove the electrode from the cooktop. that no water gets into the burner bases and the brass gas orifices. Wipe clean with a damp cloth. Be careful not to scratch, deform, or damage the bases. Allow them to dry fully befo「e using.
Troubleshooting Gas Cooktop Conversion If you encounter a problem with the cooktop, check the tables starting The cooktop is set for use with Natural Gas (NG).The factory setting below, and then try the suggested actions. is indicated on the serial plate.When set for Natural Gas(NG) operation, Checkpoints the pressure regulator will regulate the gas to 4” inches water column pressure.When set for Liquefied Propane Gas(LPG)operation,the Gas safety Problem You smell gas.
TGC3001 BURNER PERFORMANCE Total number of cooktop Burners 4Burners Left Front 18000 BTU/H Left Rear 12000 BTU/H Right Front 9000 BTU/H Right Rear 9000 BTU/H IMPORTANT: After replacing the natural gas to LP orifices, be sure to keep the original factory installed natural gas orifices for future range conversion back to natural gas. Tools for LP Conversion 7mm Tool – Top Burner Orifice Replacement Flat Screw Driver ￠2.
3.Convert Burner Valves for LP/Propane Gas 4.Reconnect Gas and Electrical Supply to Cooktop. 5.Installation of New LP / Propane Rating / Serial Plate Leak testing of the appliance shall be conducted according to the Record the model and serial number on the LP / Propane Rating installation instructions provided with the cooktop. Checking for serial plate provided in this kit. The information can be obtained Manifold Gas Pressure .
Warranty This product has been manufactured by Thor Group, 4651 E Airport Drive, California 91761 For Customer Service, please call (877) 288 - 8099 For the most up to date warranty and service policy, please refer to our website WWW.THORKITCHEN.COM/WARRANTY-REGISTRATION For in-warranty service requests, please visit our website at WWW.THORKITCHEN.
WELCOME TO THE CLUB You chose THOR Kitchen to enhance your culinary journey and we’re stoked to have you in the club. Think of it as a secret society of really savvy people, such as yourself, choosing professional power and performance at an affordable price. Register your product by following the steps below. WARRANTY REGISTRATION Scan theQR code or visit thorkitchen.com/warranty Input your product info and select register You’re done. Let’s get cookin’.
