Manual Spec Sheet

!
Using the cooktop burners
To light a burner:
1. Your cooktop equip with an automatic ignition system and
then turn anticlockwise to the ignite position,push in the control
knob,the knob LED turns on and you will hear a “clicking” sound
indicating the electronic ignition system is working properly.
2. After the cooktop burner lights, turn the control knob to shift it
out of the Lite position and turn off the electronic ignition
system.
3. Turn the control knob to adjust the flame Level.
WARNING
ELECTRICAL REQUIREMENTS
· Flames larger than the cookware bottom may result in a fire or
physical injury.
· After turning on a surface burner, make sure that the burner has
ignited even if the knob LED is on. Adjust the level of the flame by
turning the burner knob.
· Always turn off the surface burner controls before removing cookware.
All surface burner controls should be turned OFF when you are not
cooking.
· Always turn the burners off before you go to sleep or go out.
· If you smell gas, turn off the gas to the cooktop and call a qualified
service technician. NEVER use an open flame to locate a leak.
· If the LED on the control knob doesn't go on when the surface burner
has ignited,please call Thorkitchen customer service.
· If the knob LED illuminates, but the surface burner does not ignite,
turn off the control knob immediately.
· Do not operate the burner for an extended period of time without
cookware on the grate. The finish on the grate may chip without
cookware to absorb the heat.
· Be sure the burners and grates are cool before you place your hand,
a pot holder, cleaning cloths or other materials on them.
Thor Kitchen Gas cooktop requires 110 volts, 50/60 Hz
electrical supply to operate the ignition system.
Ignition
!
!
WARNING
CAUTION
Electrical Grounding InstructionsThis appliance is equipped with a
(three-prong)(four-prong) grounding plug for your protection against
shock hazard and should be plugged directly into a properly
grounded receptacle. Do not cut or remove the
grounding prong from this plug.
The knob LED indicates if a burner knob has been turned on.It does
not indicate if the burner flame is on.Check for an actual flame,
whether the knob LED is on or off.Make sure all cooktop burners are
properly installed. A statement of the gas supply pressure for checking
the regulator setting[The pressure stated shall be at least NG 5in
w.c/LP 10in w.c above the manufacturer’s specified manifold
pressure.]
Manual ignition
If there is a power failure, you can ignite the burner manually. Use
caution when doing this.
1. Hold a long gas grill lighter to the cooktop burner you want to
light.
2. Push in the control knob for that burner, and then turn it to the
Lite position. Turn on the grill lighter to ignite the burner.
3. After the burner is lit, turn the control knob to adjust the flame
level.
Flame level
The flames on the burners should always stay under the cookware, and
should not extend beyond the cookware bottom at any time.
!
WARNING
NEVER use this appliance as a space heater to heat or warm the room.
Doing so may result in carbon monoxide poisoning and overheating
of the oven.
- 15-
- 16-