TGC3001&TGC3601
Contents Important safety information 3 Stainless steel surfaces 19 W ARN I N G : If the information in this manual is not followed exactly,a fire Overview 10 Control knobs 19 or explosion may result causing property damage, personal injury, or death.
Important safety information Read all instructions before using this appliance ·All electrical and gas equipment with moving parts can be dangerous. Please read the important safety instructions for this appliance in this manual. The instructions must be followed to minimize the risk of injury, death, or property damage. ·Save this manual. Please Do Not Discard.
Fire safety ! WARNING Gas safety ! WARNING To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following precautions. To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following precautions. ·Do not store, place, or use flammable or combustible materials such as paper,plastic, pot holders, linens curtains, gasoline or other flammable vapors or liquids near the cooktop.
Installation safety Location safety Cooktop safety ! ! ! WARNING To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following precautions. ·Have your cooktop installed and properly grounded by a qualified installer, in accordance with the installation instructions. Any adjustment and service should be performed only by qualified gas cooktop installers or service technicians.
Overview ·Before removing or changing cookware, turn off the burners. Dimension and clearance ·Remove food and cookware immediately after cooking. ·Before removing any parts of the burner for cleaning, make sure the cooktop is off and completely cool. 30" /36”Model:TGC3001/TGC3601 ·After cleaning the burner spreader, make sure it is completely dry before re-assembling. ·To avoid carbon monoxide poisoning, do not pour water into the cooktop well while cleaning.
TGC3001Circuit Diagram K1 G1 D1 LED1 G Right Front G2 CN5 D2 CN6 LED5 CN6 LED3 HW-ZB-1460-01 2 2 1 HV4 HV5 HV6 SW5 SW6 LR RR SW4 COS1 HV3 L SW3 N LF RF 24" HV2 24 ( 61 " 0m m) HV1 18" ) ( 457m m SW2 19 2.5" (63.5mm) 18" ) ( 457m m CO 6" M in m) ( 152. 4m 2 1/ L 4" CN12 6" Min m) ( 152. 4 m " 34 5 /8" Left Rear N 4" 2 1/ 18" ( 457mm) SW1 " 21 " 28 5 /8" ) (63.5mm) CHANNEL Pluse igniter 2 19 2.
TGC3601 CircuitDiagram K1 G1 What’s included D1 LED6 G Right Front G2 1 2 3 4 5 6 7 K2 CN5 D2 CN6 LED5 LED4 HW-ZB-1460-01 LED3 G Right Rear 2 K5 G5 2 1 D4 CN12 G4 LED Power board 100 X60mm 1 K4 CN1 CN1 Left Front 2 G 1 D3 CN6 G3 CN5 CN7 2 1 K3 1 2 3 4 CN4 1 2 3 4 5 6 7 Middle Front 1 2 3 4 5 6 7 8 3 1 2 3 4 5 6 7 8 G D5 LR CR RR LF RF CF LED2 G Plug AC Male HV3 HV4 HV5 HV6 SW4 SW5 SW6 COS1 SW3 L HV2 N HV1 PE SW2 INPUT:AC 120V BLACK (L) WHI
ELECTRICAL REQUIREMENTS Thor Kitchen Gas cooktop requires 110 volts, 50/60 Hz electrical supply to operate the ignition system. ! WARNING Electrical Grounding InstructionsThis appliance is equipped with a (three-prong)(four-prong) grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from this plug.
Cookware Requirements Install the grates Wok Ring ·Flat bottom and straight sides ·Tight-fitting lid ·Well-balanced with the handle weighing less than the main portion of the pot or pan. Install the grates as instructed below for longest life. Woks are often used for stir frying, pan frying, deep frying, and poaching. The provided wok ring supports 12” to 14” woks 1.Turn off all burners, and wait until the grates completely cool down. 2.Place the wok ring on any grate. 3.Put a wok on the wok ring.
Stainless steel surfaces Control knobs Burner grates and components 1.Do not remove any spills, spots, and grease stains using Make sure all surface burner knobs are in OFF position. Turn off all surface burners and make sure they have 1.Grasp each knob and pull straight up to remove all cooled down. 2.Clean the knobs with soft cloth and warm, soapy water. 1.Remove the burner grates. Then rinse and dry them thoroughly. 2.Remove the burner caps from the burner heads. and location.
Burner bases ! CAUTION The burner bases cannot be removed for cleaning. Make sure NOTE deform, or damage the bases. Allow them to dry fully before using. Electrodes Do not attempt to remove the electrode from the cooktop or burner bases.Be careful not to push in any cooktop controls while cleaning the cooktop. A slight electrical shock might result which could cause you to knock over hot cookware. Make sure that the white ceramic electrodes in the cooktop Burner cap Round Burner head 1.
Troubleshooting Gas Cooktop Conversion If you encounter a problem with the cooktop, check the tables starting The cooktop is set for use with Natural Gas (NG).The factory setting below, and then try the suggested actions. is indicated on the serial plate.When set for Natural Gas(NG) operation, Checkpoints the pressure regulator will regulate the gas to 4” inches water column pressure.
TGC3001 BURNER PERFORMANCE Total number of cooktop Burners 4Burners Left Front 18000 BTU/H Left Rear 12000 BTU/H Right Front 9000 BTU/H Right Rear 9000 BTU/H IMPORTANT: After replacing the natural gas to LP orifices, be sure to keep the original factory installed natural gas orifices for future range conversion back to natural gas. Tools for LP Conversion 7mm Tool – Top Burner Orifice Replacement Flat Screw Driver ￠2.
3.Convert Burner Valves for LP/Propane Gas 4.Reconnect Gas and Electrical Supply to Cooktop. 5.Installation of New LP / Propane Rating / Serial Plate Leak testing of the appliance shall be conducted according to the Record the model and serial number on the LP / Propane Rating installation instructions provided with the cooktop. Checking for serial plate provided in this kit. The information can be obtained Manifold Gas Pressure .
Warranty This product has been manufactured by Thor Group, 13831 Oaks Ave, Chino, California 91710. Thor Group disclaims all express warranties except for the following: This warranty applies to products purchased and located in the United States. Products purchased or located outside this area are excluded.
