User Manual

29 UNPACKING AND SET-UP
In the next step, you now put on the dust cover.
If you want to operate the device without a dust
cover, skip this step.
To do this, remove the dust cover and hinges of
the packaging and install the it as described in the
following steps:
First, put the two hinges ready to use (Fig. 5) and
push with the open side over the recesses prepared
in the rear wall of the hood (Fig. 6). Conveniently,
the dust cover lies flat on the top, for example on a
table.
Now take the thus prepared dust cover and careful-
ly push the lower part of the hinges into the corre-
sponding guides on the frame (Fig. 7).
Fig. 5
Fig. 6 Fig. 7