Technical Specifications

Fibered Aluminum
Roof & Mobile Home Coating
Revised: 08/19
Manufacturer:
ThorWorks Industries, Inc.
2520 S. Campbell St.
Sandusky, OH 44870
Phone: [phone]
Fax: [phone]
Description
A blend of pure waterproofing asphaltum aluminum
pigments plus the addition of non-asbestos fibers. This
material is designed for use on severely weathered
surfaces. This material will reflect up to 80% of the
sun’s rays, helping prevent excessive drying and
cracking of substrate, thus reducing leaks. Areas
immediately under roof will remain approximately
15 °F to 20 °F cooler in summer. In winter, inside heat
is reflected back into the building, thus saving energy
costs. Great for mobile homes and metal surfaces.
Uses
Mobile Homes, Residential Homes, and Commercial
Buildings
Surface Preparation
Clean surface with brush or broom, removing all loose
sediment and dirt. Nail down any loose parts.
Application
Mix thoroughly before applying and mix frequently
while using to ensure even distribution of the
aluminum pigment. Uniformly coat the entire surface
with the coating using a roofing brush or roller.
Apply evenly and do not over brush. For best results,
apply only on a dry surface when temperatures are
not expected to drop below 50 °F during the next
12 hours. Depending on surface condition, two
applications may be necessary. Avoid applying material
during period of high humidity. Do not apply if rain is
imminent within 24 hours of application.
* If material appears too stiff during cold weather,
keep in warm area before using. Keep container
tightly closed when not in use. Stir before and during
use.
Drying Time
Allow 24 hours depending on weather conditions.
Clean Up
Clean tools with mineral spirits or kerosene in a
well ventilated area immediately after use.
Coverage (Approximate)
Metal Surface: 70-100 sq. ft. per gallon
Composition Surface: 40-60 sq. ft. per gallon
Precautions
• Do Not Heat or Thin
• Do Not Store at Temperatures Above 100 °F
• Do Not Apply Over Coal Tar Surfaces
• Do Not Apply Where Hydrostatic Pressures
Could be Encountered
• Combustible. Contains Petroleum Distillate.
Keep away from heat and flame
• Do not apply to surfaces with slopes less than 1/8”
per ft. Results may be less than optimum if
material is applied to surfaces above 120 °F
Safety And Environmental Precautions
• Refer to Material Safety Data Sheet Before Using
• For Exterior Application Only
• Close Container When Not in Use
• Environmental Information is on the
Safety Data Sheet
• Do Not Reuse Empty Container
• Volatile Organic Content (VOC) is 500 gm/liter
max.
• Apply in a well ventilated area. If you experience
eye watering, headaches or dizziness, increase
fresh air or wear respiratory protection (NIOSH
MSHA TC 23C or equivalent) or leave the area.
• Avoid contact with skin
• KEEP OUT OF REACH OF CHILDREN
NOTICE: Reports have associated repeated and
prolonged occupational overexposure to solvents
with permanent brain and nervous system damage.
Intentional misuse be deliberately concentrating and
inhaling the contents may be harmful or fatal.
CONTAINER MAY BE HAZARDOUS WHEN EMPTY
as container may contain product residues and/or
combustible vapors. All labeled hazardous precautions
must be observed. Dispose of empty container in
accordance with local, state or federal regulations.
INGREDIENTS: CAS No.
Mineral Spirits
Petroleum Asphalt
Aluminum Flake
Amorphous Siliceous Mineral
Cellulose Fibers
Calcium Carbonate
Magnesium Carbonate
Silicic Acid
64742-88-7
8052-42-4
7249-90-5
9376-70-3
9004-34-6
1317-65-3
546-93-0
63231-67-4