User Manual

Appendix B: Command reference
98-148232-B SMS remote commands 97
<rsms_pwd> <rsms_pwd> Remote SMS password
<category> 1
2
3
4
Delete only Read SMS messages
Delete Read and Sent
Delete All except Unread
Delete All SMS messages
<info_mode> 1
2
For GPS query: position data only. For other queries: use verbose mode (with
titles)
For GPS query: position data plus SMS usage. For other queries: use terse
mode (no titles)
<dataset> GPS
USAGE
ALL
GPS position
Cumulative call time and data usage
GPS position plus call time and data usage
<reset_type> 1 Normal delay restart
<wdog_op> 1
2
Get watchdog configuration
Set watchdog parameters
<ping[1/2/3]> <IP addr>
NA
Up to three ping destination IP addresses
Placeholder when no IP address is specified
<ping_always> 0
1
NA
Send ping only if no traffic
Always send ping, regardless of data traffic
Placeholder when no value is specified
<ping_interval> <integer>
NA
Interval between pings (minutes)
Placeholder when no value is specified
<wdog_enable> 0
1
NA
Disabled
Enabled
Placeholder when no value is specified. The existing setting applies. Used if
you want to change one of the other parameters without changing the
enabled/disabled setting.
<imei> <14 digits> IMEI of the EXPLORER 540, without dashes or check digit
<resp_mode> 0
1
2
3
None – send no responses to AT commands
Immediate - immediate responses, but not unsolicited
Final – suppress immediate if OK, plus unsolicited
All – send both immediate and unsolicited responses
<at_cmd> <at_cmd> AT command, without prefix AT. For supported AT commands, see ATCO
commands on page 100.
Parameter Values Meaning