User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Appendix B: Command reference
98-148232-B SMS remote commands 98
SMS reject responses
Reject Response SMS Possible Cause
WRONG PASSWORD Authentication Failure
ATCO ERROR Unable to send AT command to ATC handler
COMMAND NOT SUPPORTED Attempt to use an SMS command not
supported by the target platform
WRONG QOS Invalid QoS Requested (only a QoS of 1 is
valid).
WRONG CONNECTION TYPE(NO DHCP TE) No DHCP TEs connected to the Remote Unit
WRONG CONNECTION TYPE(NO STATIC TE) No Static TEs added in Terminal settings
WRONG CONNECTION TYPE(NO TEs) No TEs are connected to the Remote Unit
ACT/DEACT PARM PROBLEM The <IP addr> provided for an ACTIVATE or
DEACTIVATE command is incorrect (for
ACTIVATE, it must be in same subnet as the
EXPLORER 540 IP and not be the
EXPLORER 540 IP; for DEACTIVATE, it must
exist as a local or global IP address in the
existing PDP table).
INVALID RESTART REQUEST Attempt to perform restart before
EXPLORER 540 has been running for at least
15 minutes
INVALID WATCHDOG PING ADDRESS Entered Ping address is out of range (0.0.0.0
– 255.255.255.254)
INVALID WATCHDOG PING FREQUENCY Requested Ping Frequency is less than the
minimum (5 minutes)
INVALID WATCHDOG REQUEST "Ping required" or "wdog enabled" fields
incorrect in remote SMS message, or
watchdog request other than "get" attempted
ERROR: TERMINAL BUSY An ACTIVATE or DEACTIVATE command is
in progress