User Manual

Appendix B: Command reference
98-148232-B AT commands 104
Other M2M related AT commands
Parameters for other M2M related AT commands
The table below summarizes the available parameters for the AT commands for M2M
operation.
Command Parm1 Parm2 Parm3 Parm4
_ISMSRMT
<enable>
_ICLCK
<type> <enable> <passwd>
_IPWSAVSCHD
<psmode> <psvalue>
_IMACLOC
<enable> <interface> [<interface>]
_IMACLOCAD
<action> <interface> <MAC Address> [<MAC
Address>]
a
a. Up to 10 MAC addresses may be specified.
_ITGPIO
<active>
Parameter Values Meaning
<enable> 0
1
Disable
Enable
<passwd> <passwd> The existing administrator password
<psmode> IDLE_TRG
TOD_TRG
The power save mode to be set up is “idle trigger”, that is the time with no
activity before entering power save mode
The power save mode to be set up is “time of day”, that is a specific time of
day where the EXPLORER 540 wakes up from power save mode.
<psvalue> <idle-minutes>
<HH:MM>
Used with IDLE_TRG (above). Number of minutes (e.g. 15)
Used with TOD_TRG (above). Time of day (e.g. 23:30)
<interface> 0 0 means Ethernet interface. This is the only option.
<action> 0
1
Delete
Add
<MAC
Address>
<MAC Address> MAC address(es) for MAC locking. Up to 10 MAC addresses are permitted.
<active> 0
1
Inactive. The GPIO pin is in its inactive state.
Active. The GPIO pin is in its active state.