User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Appendix B: Command reference
98-148232-B AT commands 106
<Guaranteed
bitrate UL>
<Guaranteed
bitrate UL>
NA
The guaranteed bit rate up link (32, 64, 128)
Placeholder when Standard data is selected
<Guaranteed
bitrate DL>
<Guaranteed
bitrate DL>
NA
The guaranteed bit rate down link (32, 64, 128)
Placeholder when Standard data is selected
<packet filter
identifier>
<packet filter
identifier>
The packet filter identifier (1 – 8)
<evaluation
precedence
index>
<evaluation
precedence
index>
The evaluation precedence index defines the order in which the traffic flow
filters are applied to packets. 0 is first, then 1, 2 etc.
<source addr &
subnet>
<source addr &
subnet>
This is an IPv4 IP address and subnet mask. (0.0.0.0.0.0.0.0 to
255.255.255.255.255.255.255.255)
<protocol
number>
<protocol
number>
This number is uniquely assigned for the protocol being used. TCP is set to 6,
and UDP is set to 17. The protocol number determines which protocol is
used by the traffic flow filter. (0-255)
<destination
port range>
<destination port
range>
Destination port range in the form From.To
To indicate only one port number, type in the same port number under From
and To.
Example: 65333.65338 indicates port numbers from 65333 to
65338, both included.
<source port
range>
<source port
range>
Source port range in the form From.To
See above for example
<p_cid> <p_cid> The primary context to which the secondary context is related
<state> 0
1
Deacativate
Activate
Parameter Values Meaning