User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
98-148232-B 108
Appendix C
BGAN non-M2M functions
C
This appendix includes the features and functions in the EXPLORER 540 that are not available with an
M2M subscription, but only with a standard BGAN subscription.
These functions are:
•Streaming
•VoIP
To control data connections from web interface (BGAN)
The startup page of the web interface is used to start and stop data connections and to set up
the data connections.
The difference from the M2M version is, that Streaming connections are supported.
To start and stop data connections
To start and stop data connections on your EXPLORER 540, do as follows:
1. In the opening page, locate the connection package you want to start.
2. Click
to start the connection. If more connections are included in the connection
package, this will start all included connections. The connections icon at the bottom of the
page shows when a BGAN data connection package is running.
3. Click
to stop the connection.
Note
The icons for starting and stopping connections are only displayed if the
terminal is ready and registered on the BGAN network. Otherwise you cannot start
data connections.
Note
Once a Streaming connection is started, the connection will run until you stop it.
You will be charged for the time you are connected.