User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Appendix C: BGAN non-M2M functions
98-148232-B To manage VoIP phones or smartphones 114
To manage VoIP phones or smartphones
Overview
This section describes how to manage VoIP phones or smartphones connected to the
EXPLORER 540.
The terminal supports connection of up to 16 phones through the LAN interface. Each phone
must have a local number in the range 0501 to 0516 as well as a unique password. For details,
see the next section.
For details on SIP settings and how to connect your phone to the LAN interface, see To
connect a VoIP phone or smartphone on page 111.
To manage VoIP phones or smartphones in your EXPLORER 540
Do as follows:
1. Connect your smartphone or your VoIP phone via a router/switch to the LAN interface. For
details, see To connect a VoIP phone or smartphone on page 111.
2. In the web interface, select
(Control panel) > IP handsets.
3. Click the tile for the handset number you want to manage.
4. Select Enable to enable the handset.
•
on the tile for your handset means the handset is disabled.
•
on the tile for your handset means the handset is enabled.
5. To change the Password, simply type in the new number.
6. Set the call type for incoming calls.
You can select Standard voice or 3.1 kHz audio or both.
• If you select both, the handset will react (ring) on incoming calls.
• If you select e.g. Standard voice, the handset will only react on calls made to the
Standard voice phone number.
7. Select the Preferred outgoing call type.
The selected type will be used by default, if possible, for any outgoing call from this
handset.
8. Click Save.
9. In the smartphone or IP handset, enter the local number and the password you just
entered in the EXPLORER 540. See the documentation for your handset for details.
The handset remains in the list after disconnecting. When the handset is connected again, it is
automatically recognized and ready for use, if enabled.
Note
It may take some seconds to enable the handset.
Note
The user name is also the local number for the handset.