User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Chapter 2: To get started
98-148232-B To access the web interface 14
To access the web interface
You can use the built-in web interface for configuration and operation of the EXPLORER 540.
To access the web interface, do as follows:
1. Start up the terminal.
2. Connect your computer to the LAN interface of the terminal. If the terminal is already
installed in your system, you must connect via a router or switch, because there is only one
LAN interface on the EXPLORER 540.
3. Open your browser and enter the IP address of the terminal in the address bar. The default
IP address of the terminal is 192.168.0.1.
4. Log in as user or administrator. Default user names and passwords are:
• user: User name = user, password = <serial number of the EXPLORER 540>
• administrator: User name = administrator, password = admin
If the terminal is not yet installed, it will automatically start the installation procedure and the
web interface will show the progress. Otherwise the web interface will show the dashboard.
For more information on the web interface, see The web interface on page 39.
Important
Remember to change the administrator password! See To change the
administrator password on page 62.