User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Chapter 3: Operation
98-148232-B To access the terminal from a remote location 22
CLEAR: Delete SMS messages in the EXPLORER 540
The text in the CLEAR SMS must have the following format:
CLEAR <category> SMS <rsms_pwd>
Example: To delete all SMS messages from the EXPLORER 540, send an SMS to the terminal
with the text: CLEAR 4 SMS remote
Response:
No response is sent for this command.
GETINFO: Retrieve information from the EXPLORER 540
The text in the GETINFO SMS must have the following format:
GETINFO <info_mode> {GPS|ALL|USAGE} <rsms_pwd>
Example: To request all information with titles, send an SMS with the text:
GETINFO 1 ALL remote
Response: The response depends on the requested format (GPS/ALL/USAGE) and info mode.
For the command in the example, the response would have the titles shown below.
Example: IMSI: 901112112456789
IMEI: 35393803001003
LAT: 32.89495
LON:-117.20205
SW: 1.0
C/N0: 66
Beam: 84
Uptime: 59483
GIP: 161.30.23.43
The Uptime is in seconds, and GIP is the global IP address of the first active PDP context.
RESTART: Restart the EXPLORER 540
The text in the RESTART SMS must have the following format:
RESTART 1 BGAN <rsms_pwd>
Example: To restart the EXPLORER 540, send an SMS with the text:
RESTART 1 BGAN remote
Response:
No response is sent for this command.