User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Chapter 3: Operation
98-148232-B Security setup 28
3. Set new password for remote SMS:
AT_ICPWD=RS,<old password>,<new password>
Example: AT_ICPWD=RS,remote,mysmspwd
When you get an OK reply the password for remote SMS access is set to the new password
(mysmspwd in the example).
4. Disable/enable remote SMS commands:
Disable: AT_ISMSRMT=0
Enable: AT_ISMSRMT=1
5. Specify a white list of trusted MAC addresses:
AT_IMACLOCAD=1,0,<MAC address>[,<MAC address> (etc.)]
Example: AT_IMACLOCAD=1,0,00:B5:E0:76:FD:C2,00:B5:A0:84:F9:E2
When you get an OK reply, the specified MAC addresses are added to the white list.
6. Turn on MAC address filtering:
AT_IMACLOC=1,0
When you get an OK reply, MAC address filtering is enabled for Ethernet, and only the
MAC addresses specified in the white list can get access (previous step).
7. Enable administration lock:
AT_ICLCK=AD,1,<password>
Example: AT_ICLCK=AD,1,myadmpwd
When you get an OK reply, the system is protected with the administrator password.
To set up the security with the web interface
If you want to setup the security with the web interface, see the following sections:
• User and administrator passwords for web interface: Passwords on page 62
• Admin password for AT shell (same as for web interface): Passwords on page 62
• Password for remote SMS access: To set up remote access with SMS on page 69
Note
The password cannot contain spaces, e.g. “new pw” is not accepted, whereas
“new_pw” is accepted.
Important
If you disable remote SMS commands there is no way to access the terminal
remotely, unless you have an open data connection (PDP context)! Instead
we recommend to define a set of trusted phone numbers, see To set up
remote access with SMS on page 69.
Note
Until MAC address filtering is enabled, all MAC addresses are allowed and the
white list has no effect.
Important
Remember to add the MAC address of your own device. Enabling the MAC
address locking without adding your own device MAC address will block for
any local access to the Terminal!